Fan 12V 2x 3D Printer Cables

TP4056 Lithium Battery Charger Module 5V mini USB features:
- Based on TP4056ES regulator
- Lipo mini USB Li-Ion charger
- Input Voltage: 4.5V - 5.5 VDC
- Full charge voltage: 4.2V +/- 1.5%
- Max Output Current: 1A
- Indicator LED: charging red, charging green
- Operating temperature: -10ºC to + 85ºC
- IN + and IN- connection for electronic circuits
- Battery protection against over-discharge voltage: 2.5V - Protection against over current battery: 3A
- Measurements: 25x19x5 mm
- Ideal for 18650 batteries

- The XL6009 module has a superior performance than the LM2577 module
- The regulator-booster of High performance
Characteristic:
- Based on the XL6009E1 regulator
- Input voltage: 3V-32V,
- Output voltage: 5-35V (adjustable),
- Output current: 2A maximum 3A (heat sink is required)
- Conversion efficiency: up to 94%
- Rectifier: not synchronous rectification
- Short circuit protection: current limitation, since recovery
- Operating temperature: industrial grade (-40 ° C - 85 ° C)
- Load regulation: ± 0.5%
- Voltage regulation: ± 0.5%
- Size: 50 x 22 x 15 mm

Resistor 220 Ohm 5% 0,25W 1/4W features:
-220 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Ideal to power your Arduino board through the power input.
5x 9v Battery Adapter Connector 6F22 with Cable features:

- Cable 15cm long
- Battery connector 9V, 6F22

10x 8-Pin Long Female Strip features:
- Pin spacing: 2.54mm
- Pin length: 10.5mm - Insertion position: Vertical
- Insertion: Through
- Quantity: 10 units of 8-pin female strips each

- Immerse the probe in the fish tank to measure the water temperature Digital Thermometer with External Temperature Probe features:
- Cable length: 1m
- LCD screen
- Temperature range: -50 C ~ + 70C
- Powered by 2 batteries x LR44 / AG13 button (included)
- Cable length: approx.100cm
- External Dimensions: 48 x 28.5 x 15.2 mm
- Dimension LCD screen: 35 x 16 mm
- Color: Black
- Used to measure the temperature in: the rooms, the aquarium, terrarium in the heating system, in the car, fridge, freezer

The humidity sensor DHT11 comes in a plastic body ideal for mounting on a panel or similar. It uses a capacitive sensor that returns a digital signal with the measurement. DHT11 Temperature and Humidity Sensor features:
- Operating voltage: 3 to 5 VDC
- Humidity measurement range: 20-95% ± 5% accuracy
- Temperature measurement range: 0ºC to 50ºC ± 2º accuracy
- Maximum sampling rate: 2 seconds
- Working current 2.5mA
- Iterfaz 1-wire
- Dimensions: 2.3 x1.2x 0.5cm
- Quantity: 1 unit

Mounting Bracket for Nema Engine 17 42mm features:
- Steel bracket for PAP Nema 17 3D printer motor
- Mounting bracket of 42mm L shape alloy steel for The NEMA17 3D Stepper Motor Printer
- Material: Alloy Steel - Size: 5 x 5 x 5cm
- Black Color
- Fit for 42mm Stepper Motor as NEMA17