10x 8-Pin Long Female Strip

The integrated mainboard driver MKS-GEN L V1.0 for 3D printer has been developed by Makerbase to optimize existing problems on the open source controller board such as Ramps 1.4.
This product offers more flexible options for users.
MKS-GEN L V1.0 Integrated Controller Compatible with Ramps 1.4/Mega2560 R3 features:
- Mega2560 and Ramps 1.4 are integrated in the board, which avoids the complicated connectors.
- Supports a variety of step-by-step drivers such as A4988, DRV8825, TMC2100 and LV8729, available to change stepper motors and motors that users like.
- Reserve the signal from the external controller, available to connect an external high current driver to drive stepper motors 57 and 86.
se high quality MOSFET, better cooling and more stable.

Flat Cable GPIO 40 Pins M/F features:
- For Raspberry Pi 2 and Pi 3, B and B +
- Total length 20cm
- Quantity: 1 unit

LED 10-Segment Bar Graphics Display Red features:
- Bargraph LED display
- Number of segments: 10
- Size: 5mm - Dimensions: 25x10mm
- Material GaAsP / GaP
- Color: red
- Wavelength: 635 nm
- Vf / forward /2.1 V
- I fw / forward / 30 mA
- Iv / Ifw = 20mA / 4 mcd
- Number of terminals: 20

Electronic Prototype ABS Plastic Black Box 100x60x25 features:
- Box for electronic projects, power supply units, student projects,
amplifiers, etc
- Dimension 100x60x25 mm

The module has two outputs: analog A0 and digital D0
Digital output D0 - signal 0 appears or 1 depending on the threshold setting
The threshold is set with the potentiometer
The sensor can be used for example:
Automatic watering for potted plants
With this module you will be able to measure the humidity of the soil, so that you will be able to control the humidity level of the soil of your plants
Characteristic:
Operation: 3.3V -5V
- Sensitivity adjustable by potentiometer
- Dual output mode: analog and digital
- Red LED - power indicator
- Green LED - indicator digital switching output
- PCB measurements: 3 x 1.5 cm
- Probe measurements: 6 x 3 cm

10x Female Strip 10 Long Pins features:
- Pin spacing: 2.54 mm
- Pin length: 10.5 mm
- Insertion position: Vertical
- Insertion: Through
- Quantity: 10 units of female strips of 10 pins each

Level sensor for liquids with float.
The liquid level sensor acts as a switch. The state is changed by means of a magnet located on the float. It can be used to detect liquid levels that are too high or too low.
Ideal for all those applications where it is necessary to control the level of non-corrosive liquids such as water tanks, aquariums.
Characteristic:
- Maximum Load: 50W
- Maximum Switching Voltage: 250V
- Maximum Switching Current: 0.5A
- Maximum charging current: 1A
- Operating temperature: -10ºC to + 60ºC
- Size: 58mm x 18mm

2 Double Side Prototype PCB Board 6x8cm features:
-Thickness of PCB: 1.6mm
-Material: high quality FR-4 glass fiber PCB
-Presented and numbered on both sides
-Top and bottom are identical copper layers
-Pads grid (pitch) 2.54mm/0.1", hole diameter 0.9mm