Voice Recording and Reproduction Module ISD1820 This module works under the characteristics of the integrated ISD1820 and allows you to make recordings of multiple messages or the reproduction thereof, it performs a non-volatile storage. Voice Recording and Reproduction Module ISD1820 features: - Working voltage: 2.4 - 5.5 VDC- Model: I073103- Voice Recorder Chip ISD1820- Automatic ignition mode dwoncording duration: 8-20 seconds- Manual or Automatic Control with an MCU- With internal audio amplifier, this board can drive 8 ohm 0.5W speaker directly- Includes a microphone on board to record directly- The sampling frequency and duration can be different if a single module resistance is changed- High quality, restored natural voice, can be used as a speaker module Code M0157 Available Regular price €6.95 -€1.96 Price €4.99
HC-SR04 Ultrasonic Sensor Distance Measuring Module It is very easy to make it work with an Arduino, PIC or any other microcontroller. In its output pin we will be able to measure the PWM pulse width depending on the distance of the obstacle. HC-SR04 Ultrasonic Sensor Distance Measuring Module features: - Supply voltage: 5V (4.5V- 6V) - Consumption: 30 mA typical, (35 mA max) - Interface: VCC , GND, Signal - Range: 2 cm to 3 meters - Angle 15º - LED indicator of measurement in progress - Frequency: 40 kHz for 200 µs - Size: 30mm x 20mm - Quantity: 1 unit Useful links for Arduino / Raspberry programming and projects with boards Arduino / Raspberry: Automatic robot operation with obstacle detection /> Code S0007 Available Price €1.79
Photoresistor GL5516 LDR 10x Photoresistor 5mm GL5516 LDR 5-10k for Arduino.Photoresistor is a resistor whose resistance decreases when increasing the intensity of the light that falls on it. 10x Photoresistor GL5516 LDR features: - Model: GL5516- Spectral peak: 540nm- Maximum DC voltage: 150V- Maximum power: 90mW.- Resistance with light (10lux): 5-10KΩ- Resistance with darkness (0lux): 0.5MΩ- Response time: 20ms- Operating temperature: -30ºC - 70ºC Code S0012 Available Price €0.15
Extension Board Shield Nano V3.0 ATmega328P Extension Board Shield for Arduino Nano V3.0. Code B0025 Available Price €2.95
Infrared LED Flame Sensor 5mm Led infrared sensor.Detector of the source of fire or flame, can detect a flame or wavelength 760 nm-1100 nmParticularly sensitive to the flame spectrum.This optical flame sensor is a device that detects the existence of combustion by the light emitted by it. Infrared LED Flame Sensor 5mm features: - Range of light, Distance of 80 cm.- Angle detection of about 60 degrees,- This light can be detected by an optical sensor,- Can be captured by digital inputs and analog inputs of Arduino. Code S0132 Available Price €0.45
Power Supply Transformer 220V AC/DC 2A 5V Power Supply Transformer 220V AC/DC 2A 5V features:- Input voltage: 100~240V 50Hz- Output voltage: DC 5V- Output current: 2A- DC connector: 5.5 mm x 2.1 mm- Cable length: Approx. 90 cm- Indicator of operation: LED diode Code A0102 Available Price €3.99
Soldering Iron 60W Soldering Iron 60W, CE Rohs compliant. Code H0199 Last items in stock Price €7.49
Anti-Static Tweezers ESD 117mm Anti-Static Tweezers ESD 117mm features: - Anti-static tweezers, curved tip, matt black- Length: 117mm- Width: 10mm- ESD pliers- High precision, without producing dust, resistant to high temperatures Code H0094 Available Price €1.79
Wireless charger module 5V 1V with transmitter coil. Wireless charging and powering of small electronic products. It is designed for small size, ease of use, high performance and low price. The main purpose of the module is to be used in the initial phase of projects such as mobile electronic products. Code A0175 Available Price €7.95
Solar Power Manager Supports 3x 18650 Batteries Solar Power Manager (C), Supports 3x 18650 Batteries, Multi Protection Circuits. Compatible with 6V~24V solar panels, Rechargeable from solar panel or C-type power adapter. 5V/3A regulated output. Code WV006 Available Price €31.95
TP4056 Module Lithium Battery Charger with Protection Micro USB TP4056 Module Lithium Battery Charger with Protection features: - TP4056 Li-Ion Micro USB Charger - Upgraded version of previous TP4056 - Micro USB connection to charge directly from the PC - Ideal for 18650 batteries - Based on the TC4056A regulator - Input Voltage: 4.5V - 5.5V DC - Full charge voltage: 4.2V +/- 1.5% - Max Output Current: 1A - Overvoltage protection 4.2V - Over discharge protection 2.4V - LED indicator: charging blue, charging red - Operating temperature: -10ºC to + 85ºC - IN + and IN- connection for electronic circuits - Overcurrent protection: 3A - Measurements 26 x 19 x 5 mm - Possibility of current change through Rprog Code A0026 Available Price €1.69
Charger 4 x 9V 6F22 with EU Power Supply Cable Charger 4 x 9V 6F22 with EU Power Supply Cable features: The everActive NC 109 charger is a unique, specialized design that allows you to charge from 1 to 4 pieces of 9V Ni-MH batteries - each cell is charged individually.It allows you to charge up to 4pcs of 9V batteries simultaneously, in any configuration / combination, with any capacity, any manufacturer.The charger has 4 independent charging channels.The most important features: of the NC109 loader:- quick charging of a large number of batteries simultaneously - ideal for industrial and professional applications,- individual LED indicator of charger work for each cell - with full charge signaling,- 100-240V AC power adapter included, optionally a 12V car adapter is available, Code A0101 Available Price €17.99
Charger XTAR MC2 2x18650 with EU Plug Cable The European lithium-ion charger for 2x 18650 batteries, has a 38cm cable. It is very convenient and easy to use. Genuine Xtar product Code H0534 ✗ Out-of-Stock Price €11.90
Battery charger BMS 3,7-96V 10A - Automatic charge controller module This 3.7-96V 10A battery charger is an automatic charge controller module that prevents the battery from dropping below a voltage level, the value of which is adjustable. It is suitable for 1.5 to 120V batteries, as using it will save time and energy. Code A0130 Available Price €10.90
Car battery tester and charger Konnwei KW510 The Konnwei KW510 is an advanced multi-function device that uses state-of-the-art technology to allow you to easily, quickly and accurately measure the actual cold start capability, battery condition and common faults in the vehicle's starting and charging systems. The KW510 is particularly useful for workshops as it can accurately detect the problem, allowing the vehicle to be repaired quickly. Code H0586 Available Price €69.95
MCP73831 - Li-Pol/Li-Ion single cell 1S 3.7V USB charger - Adafruit 1304 Charger for 1-cell lithium-polymer batteries with a nominal voltage of 3.7 V and lithium-ion batteries. The chip is powered via a USB plug, which can be connected directly to a computer socket or a power supply. Code AD002 Backorder Price €9.99
5S BMS 25A 21V 18650 PCM PCB Circuit Charging Module In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge. Code A0108 Available Price €4.69
Solar Power Manager, Embedded 10000mAh Li-Po Battery Solar power manager (B), Built-in 10000mAh rechargeable Li-Po battery, Multiple protection circuits. Compatible with 6V~24V solar panels, Rechargeable from solar panel or C-type power adapter. 5V/3A regulated output. Code WV005 Available Price €35.95
Wireless charger module 5V 1V with transmitter coil. Wireless charging and powering of small electronic products. It is designed for small size, ease of use, high performance and low price. The main purpose of the module is to be used in the initial phase of projects such as mobile electronic products. Code A0175 Available Price €7.95
Solar Power Manager Supports 3x 18650 Batteries Solar Power Manager (C), Supports 3x 18650 Batteries, Multi Protection Circuits. Compatible with 6V~24V solar panels, Rechargeable from solar panel or C-type power adapter. 5V/3A regulated output. Code WV006 Available Price €31.95
TP4056 Module Lithium Battery Charger with Protection Micro USB TP4056 Module Lithium Battery Charger with Protection features: - TP4056 Li-Ion Micro USB Charger - Upgraded version of previous TP4056 - Micro USB connection to charge directly from the PC - Ideal for 18650 batteries - Based on the TC4056A regulator - Input Voltage: 4.5V - 5.5V DC - Full charge voltage: 4.2V +/- 1.5% - Max Output Current: 1A - Overvoltage protection 4.2V - Over discharge protection 2.4V - LED indicator: charging blue, charging red - Operating temperature: -10ºC to + 85ºC - IN + and IN- connection for electronic circuits - Overcurrent protection: 3A - Measurements 26 x 19 x 5 mm - Possibility of current change through Rprog Code A0026 Available Price €1.69
Charger 4 x 9V 6F22 with EU Power Supply Cable Charger 4 x 9V 6F22 with EU Power Supply Cable features: The everActive NC 109 charger is a unique, specialized design that allows you to charge from 1 to 4 pieces of 9V Ni-MH batteries - each cell is charged individually.It allows you to charge up to 4pcs of 9V batteries simultaneously, in any configuration / combination, with any capacity, any manufacturer.The charger has 4 independent charging channels.The most important features: of the NC109 loader:- quick charging of a large number of batteries simultaneously - ideal for industrial and professional applications,- individual LED indicator of charger work for each cell - with full charge signaling,- 100-240V AC power adapter included, optionally a 12V car adapter is available, Code A0101 Available Price €17.99
Charger XTAR MC2 2x18650 with EU Plug Cable The European lithium-ion charger for 2x 18650 batteries, has a 38cm cable. It is very convenient and easy to use. Genuine Xtar product Code H0534 ✗ Out-of-Stock Price €11.90
Battery charger BMS 3,7-96V 10A - Automatic charge controller module This 3.7-96V 10A battery charger is an automatic charge controller module that prevents the battery from dropping below a voltage level, the value of which is adjustable. It is suitable for 1.5 to 120V batteries, as using it will save time and energy. Code A0130 Available Price €10.90
Car battery tester and charger Konnwei KW510 The Konnwei KW510 is an advanced multi-function device that uses state-of-the-art technology to allow you to easily, quickly and accurately measure the actual cold start capability, battery condition and common faults in the vehicle's starting and charging systems. The KW510 is particularly useful for workshops as it can accurately detect the problem, allowing the vehicle to be repaired quickly. Code H0586 Available Price €69.95
MCP73831 - Li-Pol/Li-Ion single cell 1S 3.7V USB charger - Adafruit 1304 Charger for 1-cell lithium-polymer batteries with a nominal voltage of 3.7 V and lithium-ion batteries. The chip is powered via a USB plug, which can be connected directly to a computer socket or a power supply. Code AD002 Backorder Price €9.99
5S BMS 25A 21V 18650 PCM PCB Circuit Charging Module In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge. Code A0108 Available Price €4.69
Solar Power Manager, Embedded 10000mAh Li-Po Battery Solar power manager (B), Built-in 10000mAh rechargeable Li-Po battery, Multiple protection circuits. Compatible with 6V~24V solar panels, Rechargeable from solar panel or C-type power adapter. 5V/3A regulated output. Code WV005 Available Price €35.95