Extension Board Shield Nano V3.0 ATmega328P

ATmega328P Nano V3.0 Adapter Terminal Block Connector features:
- Nano V3.0 Atmega328P adapter with loose connectors and solder pins
- PCB dimensions: 53mm x 35mm

Screw Shield V2- Arduino ScrewShield UNO features:
Screw Shield V2 allows: - Being punctured directly to an Arduino Uno
- Facilitate the connection of different modules, such as sensors, relays, servos, buttons, potentiometers and more.

This is your simple three conductor sensor cable with electrode pad wires. These cables measure 24" long and feature a 3.5mm audio jack on one end with snap type receptacles for biomedical sensor pads.

Simple breadboard for your MyoWare Muscle Sensor. You can use the provided area of the shield to solder in any custom circuit you can think of. This shield provides 8 x 15 solderable through holes on a standard 0.1" grid.

A remote monitoring and control solution, optimised for outdoor environments. Collect real-time data from smart sensors and leverage everything to the edge, in your smart farm management.

Nicla Sense ME is the smallest Arduino-developed board equipped with a range of the latest Bosch environmental and motion sensors. The module is based on the nRF52832 ARM Cortex M4 chip clocked at 64 MHz with 512 kB of Flash, 64 kB of RAM and 2 MB of SPI Flash and 2 MB of QSPI embedded memory. The Nicla Sense ME features the Bosch BHI260AP, BMP390, BMM150 and BME688 embedded sensors. 

ProtoShield Prototype Expansion Board with Mini Breadboard 170 points for Arduino Mega2560 V3.0 features:
- To mount your projects in a comfortable and orderly way, access to all the pins of Arduino Mega2560, it has a universal plate and protoboard zone, 5V and Gnd buses, reset pushbutton, pushbutton and 2 general purpose leds, zones for integrated Soic and Dip
- The seamless mini breadboard has 170 connection points.
- You can stick on the shield with its self-adhesive back.

The SparkFun Qwiic Cable Kit includes 10 cables of different lengths and styles that will connect your Qwiic boards to each other, to a development platform or to a breadboard. Each Qwiic cable is colour coded red, black, blue and yellow with 1mm JST termination.

Screw Shield V1- Arduino ScrewShield UNO y MEGA features:
Screw Shield V1 allows: - Being punctured directly to an Arduino Uno, Mega, Leonardo plate
- Facilitate the connection of different modules, such as sensors, relays, servos, buttons, potentiometers and more.

The SparkFun WiFi ESP8266 Shield is a shield for Arduino R3 R3 board enabling internet connection. ESP8266 as you all know is a solid fundament for any IoT project an in this version it can be simply and easily put on your board. It is a great middle ground between the sole module and the development board such NodeMcu or WeMos. So if you need a relatively cheap and super reliable way to internet for your Arduino project - this is the shield for you! ESP8266 shield WiFi comes with an AT-command firmware, hence can be controlled by any UART. It works great with any Arduino R· layout. The shield doesn´t have the headers on.