Resistor 470K Ohm 5% 0,25W 1/4W

15x Electrolytic Capacitor 10uF 50V 105º C PIC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 10uF
-Maximum tension: 50V
-Maximum temperature: 105º C
-Dimensions: 5x11mm
-Quantity: 15 units

Prototype Board MB-102 Protoboard 830 points Arduino features:
- 830 Connections
- Linkable with other boards
- Base with adhesive to attach it to the work surface
- Measures 165x 55x8mm

LED 5mm RGB 4 Pins cathode commun with clear water lens.

Double Side Prototype Copper PCB Board 2x8cm features:
-Thickness of PCB: 1.6mm
-Material: high quality FR-4 glass fiber PCB
-Presented and numbered on both sides
-Top and bottom are identical copper layers
-Pads grid (pitch) 2.54mm/0.1", hole diameter 0.9mm

Resistors 6,8K Ohm 5% 0,25W 1/4W features:
- 6.8 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

- The XL6009 module has a superior performance than the LM2577 module
- The regulator-booster of High performance
Characteristic:
- Based on the XL6009E1 regulator
- Input voltage: 3V-32V,
- Output voltage: 5-35V (adjustable),
- Output current: 2A maximum 3A (heat sink is required)
- Conversion efficiency: up to 94%
- Rectifier: not synchronous rectification
- Short circuit protection: current limitation, since recovery
- Operating temperature: industrial grade (-40 ° C - 85 ° C)
- Load regulation: ± 0.5%
- Voltage regulation: ± 0.5%
- Size: 50 x 22 x 15 mm

- It has an Atmega328P chip running at 16Mhz with a factory loaded bootloader - The Uno R3 module has all the connectors than the Arduino Uno R3 and is compatible with all Arduino shields Arduino compatible UNO R3 board features:
- Includes USB Cable - ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATmega328
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O Pins: 14
- Analog input pins: 6
- DC current per I / O Pin: 40 mA
- DC Current per Pin 3.3V: 50 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - Atmega328
- SRAM 2 KB - Atmega328

Potentiometer B1K Linear features:
-1k OHM kΩ - linear potentiometer 1k Arduino
-Tolerance: +/- 20%
- Power: 0.125W