Resistor 2K Ohm 5% 0,25W 1/4W

This electromagnetic push actuator allows a force of 0.8N to be exerted and has a pitch length of 10mm.
It is powered by 24VDC and has a consumption of 420mA.
This supply is used in industrial automation systems. Characteristic: - Input voltage: 24VDC - Thrust length: 10mm
- Holding force: 0.8N
- Operating temperature: -5 ° C to 40 ° C without condensation
- Humidity of operating environment: 45% to 85% non-condensing
- Push bar diameter: 0.8 cm / 0.3 "
- Material type: Metal
- Model: ZYE1-0837Z
- Actuator size: 2.6x2x6.35 cm / 1.02x0.79x2.5 "

Precision Temperature Sensor TO-92 LM335 LM335Z-ST features:
- Power supply from 5 to 30 Vdc
- Connection through analog input
- Temperature range from -40ºC to 100ºC
- Linearity +10 mV / ºK
- Accuracy of measurement: ± 2 ° C
- Manufacturer: Texas Instruments

Version compatible with Arduino Nano V3.0
It has an ATMega328P chip running at 16Mhz with bootloader loaded factory.
Characteristic:
- Microcontroller: ATmega328
- Operating Voltage (logic level): 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins: 14 (6 PWM outputs)
- Analog Inputs: 8 (A0-A7)
- DC Current per I / O pin 40 mA
- Flash memory: 32 KB (2 KB used by the bootloader)
- SRAM: 2 KB
- EEPROM: 1 KB
- Frequency Clock: 16 MHz
- USB Communication - CH340
- Dimensions: 18 mm x 44 mm

120x Female-Male Cables Female-Female Male-Male 2.54 Jumpers Dupont Arduino features:
- Length: 20cm
- Quantity: 120 cables
- Female-Female 40 units
- Male-Male 40 units
- Female-Male 40 units

The STM32F103C8T6 has characteristics that surpass the traditional Arduinos type Atmel
We go from a speed of execution 16 MHz to 72 MHz and 8-bit to 32-bit. The module is supplied in a soldered version.

Characteristic:
- Tolerance: +/- 20%
- Power: 0.125W

28BYJ-48 Stepper Motor 12V + Driver Board ULN2003 features:
- Stepper motor 28BYJ-48 + ULN2003 controller
- The 28BYJ-48 has everything you need to start using motors step by step in your project
- A stepper motor converts digital impulses into small steps of movement in one direction
- The motor also comes with a ULN2003 motor controller card
- Can control two DC motors or a motor with bipolar steps with a maximum amperage of up to 500 mA
- Equipped with state indicator LEDs A, B, C, D
- Engine model: 28BYJ-48
- Phasing Engine: 4
- Operating voltage: 12V DC
- Frequency: 100 Hz
- Operating current: 200mA
- Max Power: 20W
- Winding resistance: 70 Ohm
- Angle per step: 5,625º
- Steps per round: 64