Resistor 1M Ohm 5% 0,25W 1/4W

LM35 Temperature Sensor LM35DZ TO92 features:
- The output is linear and each degree Celsius equals 10 mV
- Power supply from 4 to 30 Vdc
- Connection through analog input
- Temperature range from 0ºC to 100ºC
- Linearity +10 mV / ºC
- Quantity: 1 unit

Magnet Round Disc Neodymium Ferrite 10x4mm features:
- External magnet dimensions: 10x4mm
- Magnet shape: round
- Magnet material: neodymium

- The XL6009 module has a superior performance than the LM2577 module
- The regulator-booster of High performance
Characteristic:
- Based on the XL6009E1 regulator
- Input voltage: 3V-32V,
- Output voltage: 5-35V (adjustable),
- Output current: 2A maximum 3A (heat sink is required)
- Conversion efficiency: up to 94%
- Rectifier: not synchronous rectification
- Short circuit protection: current limitation, since recovery
- Operating temperature: industrial grade (-40 ° C - 85 ° C)
- Load regulation: ± 0.5%
- Voltage regulation: ± 0.5%
- Size: 50 x 22 x 15 mm

Resistor 51K Ohm 5% 0,25W 1/4W features:
- 51 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Characteristic: -Conductor: solid wire, tinned copper
-Insulation: PVC
-Low voltage electrical cables - Nominal voltage 300V / 80C -Standard: UL 1007
-Number of conductors: 22AWG, 1x0.35mm2
-Outer diameter: 1.6mm

50x Ceramic Capacitor 33nF 50v 103 PCB PIC Arduino features:
-Type: ceramic Y5V
-Tolerance: +/-20%
-Dimensions: diameter 6mm, pitch 5.08mm

Orders only in multiples of 50 units

5x Strip Simple Row Male 40 Pins Header Various Colors features:
- Type: Male
- Insertion position: Vertical
- Separation between pins: 2.54mm
- Quantity: 5 strips of 40 pins Male each

This module, which uses the exclusive L298P chip for driving high-power motors, can directly control two DC motors, with a drive current up to 2A. The motor output uses eight-speed Schottky diodes as protection.
The design of the letter allows you to connect directly to the Arduino UNO R3 for easier use. Module L298P DC 2A Motor Management Shield Bluetooth Interface PWM features:
- 1 logical step of the input voltage VD: 5 VDC
- Control of the input voltage VS and control by pulse width modulation:
      - VIN input: 6 - 12 VDC
      - PWRIN input: 4.8 - 35 VDC
- Logic current flow: Iss <36m A
- Operation current management: Io <2 A
- Maximum power dissipation 25W (T = 75 ° C)
- Input of the control signal: