Raspberry Pi Sense HAT

16 servo motors with one board seems impossible? With this board not only it isn´t impossible, but it even seems easy. Additionally, you won´t need to sacrifice any of your valuable GPIOs as the HAT connects directly via I2C. Additionally, you have a serial terminal connection at your disposal.

You can supply the power to the board through your Pi or directly if you are going for larger servos and would need a separate source of power. Simply scrap a small blob of solder on the isolation jumper.

This HAT is an open source portable sensor that provides the level of suspended particulate matter quantity with its mass. It has a powerful and high-tech PMSA003 sensor that provides the information of suspended particulate matter (PM1.0, PM2.5, PM10) in the air per unit volume.

If you are into prototyping with your Raspberry (which you should be given that is what the board is for), Pimeroni Explorer HAT Pro is a great solution for you. Board is equipped with a range of inputs and outpu, which enables it to achieve range of potential applications from controlling motors, to analog sensors and 5V systems. As any Pimeroni accessory it is well compatible with all Raspberry boards and comes in with a range of Pythong libraries on github issued by Pimeroni team themselves

The Pimeroni Automation HAT (PIM213) is a great solution for home automation. The controller board includes relays, powered outputs and buffered inputs up to 24V as well as analog channels. Set of LEDs showing the current state of each of the channels. So if you need to get a light automation or garden sprinkling phasing set in place, this is the board just for you

Mini Dongle WiFi USB For pcDuino, Nano, Raspberry Pi.

T-Cobbler GPIO KIT + 40-pin Grey Flat Cable Pi B+ RPI 2 RPI 3 RPI Zero features:
- Shield to connect with breadboard
- Dimension: 6 x 7.3x 1.9mm
- Flat cable female / female 40 pins
- Total length: 25cm
- Quantity:
1x shield
1x flat cable

This little board is simply a I2C board to Qwiic converter. It pretty much enables any device with I2C connectors to work with Qwiic system. It has two Qwiic ports - both of them served with the same I2C bus. You simply stick the board on your I2C board and get additional two Qwiic ports. It is as easy as it sounds

Can't stand to run out of pins in your Raspberry Pi? You have a cool new accessory but there's no way to plug it in? If you answered yes to any of the above, then this pHAT could be just for you. This piece has 6 sets of 40 GPIOS - one for your Pi and the rest (5) for your collection of HATs that you might want to plug in at the same time. Use it for a specific project or just to play with several HATs at once.  

Pimeroni Display-O-Tron is one of the most popular and at the same time easiest to use HATs in Pimoroni offering. It is featured with 16x3 character LCD supporting a complete ASCII character set. The shield is powered directly through the Pi board. The board comes with multiple capactive touch pads on top of that. All functions of the shield are accessible in a really straight forward way and supported by a range of Python libraries available on github and officially issued by Pimoroni. The hat is compatible with all Raspbery boards given its universal 40 GPIO pinout

This fingeprint scanner from ADH-Tech combines a highly precise fingerprint sensor module with an onboard MCU and UART interface enabling trivially very connection to any project.

The scanner independently reads and analyses the fingerprint thanks to an MCU algorithm that can send a converted digital signal to a peripheral serial interface for a data read. The onboard MCU algorithm enables operations such as for example a fingerprint enroll.