Serial Expansion HAT for Raspberry Pi

The kit includes 30 basic sensors, which will help you to easily kick-start any project. The sensors are featured with a proprietary Seeed Grove connectors enabling easy connection without soldering and a comprehensive guide book with exemplary classes.

Raspberry Pi Pico HAT Expansion is an input/output expansion board designed for Raspberry Pi Pico, which provides a set of 2x20 pin headers in the form of Raspberry Pi header along with a set of 2 x 20 pins. It allows any HAT designed for Raspberry Pi to be connected to Raspberry Pi Pico.

This starter kit aims to quickly get you connected to Seeed Studio BeagleBone® Green. It contains 10 Grove modules and we provide you with 3 step-by-step projects to get you started quickly with all modules. The set comes in a handy box and is attractively priced!

This little board is simply a I2C board to Qwiic converter. It pretty much enables any device with I2C connectors to work with Qwiic system. It has two Qwiic ports - both of them served with the same I2C bus. You simply stick the board on your I2C board and get additional two Qwiic ports. It is as easy as it sounds

This fingeprint scanner from ADH-Tech combines a highly precise fingerprint sensor module with an onboard MCU and UART interface enabling trivially very connection to any project.

The scanner independently reads and analyses the fingerprint thanks to an MCU algorithm that can send a converted digital signal to a peripheral serial interface for a data read. The onboard MCU algorithm enables operations such as for example a fingerprint enroll.

Can't stand to run out of pins in your Raspberry Pi? You have a cool new accessory but there's no way to plug it in? If you answered yes to any of the above, then this pHAT could be just for you. This piece has 6 sets of 40 GPIOS - one for your Pi and the rest (5) for your collection of HATs that you might want to plug in at the same time. Use it for a specific project or just to play with several HATs at once.  

T-Cobbler GPIO KIT + 40-pin Grey Flat Cable Pi B+ RPI 2 RPI 3 RPI Zero features:
- Shield to connect with breadboard
- Dimension: 6 x 7.3x 1.9mm
- Flat cable female / female 40 pins
- Total length: 25cm
- Quantity:
1x shield
1x flat cable

QWIIC is a connection standard developed by Sparkfun enabling a quick an easy connection of peripherals without a need to solder pins, without any mismatches due to polarized connector. And on top of that you can "daisy chain" them! 

This hat pretty much opens the whole QWIIC universe in front of your Pi. It features 4 QWIIC ports all on the same I2C bus (GND, 3.3V, SDA, and SCL).

A universal  2x20 GPIO makes it compatible with all Raspberry Pi boards, as well as Google Coral and Jetson Nano.

Note:  For a secure connection in some applications, you'll need to add a pair of 1x20 stackable headers to extend the pins to your cart.

This module is used to extend the Raspberry's 40 GPIO pins to another set of 2x20 male pins and 8 parallel pins accessible on the terminal blocks in the that test leads are pushed. The electronic board offers great reliability with the Raspberry and is very easy to connect thanks to its existing suitable accessories but not included.
The module offers a set of mini jumpers to configure the GPIO.

16 servo motors with one board seems impossible? With this board not only it isn´t impossible, but it even seems easy. Additionally, you won´t need to sacrifice any of your valuable GPIOs as the HAT connects directly via I2C. Additionally, you have a serial terminal connection at your disposal.

You can supply the power to the board through your Pi or directly if you are going for larger servos and would need a separate source of power. Simply scrap a small blob of solder on the isolation jumper.