PCB Heated Bed MK3 Alu 3mm 12V 24V 3D Printer

Universal Magnetic Antenna Connector Male Plug SMA 150cm GPS features:
- Standard: GPS 1575.42 MHz
- Voltage: 3 ~ 5V
- Current: max 10mA
- Interface: SMA male
- Polarization: circular (right)
- LNA gain (without cable): 28dB typ
- Noise figure: 1.5dB typ
- Operating temperature: -40'C ~ + 85'C
- Cable length 150cm
- Dimensions: 49 x38 x16 mm

1m 6mm GT2 strap 3D printer features:
- GT2 rubber strap with fiberglass reinforced
- Length: 1m
- Width: 6mm
- Strap height: 1.38 mm

MKS MOS25 is the Mosfet printer heating module for heated bed that supports current up to 25A. We recommend MKS MOSFET, especially if you are trying to use a heated bed with your 3D printer and 12V power supply.

SIM808 GPRS GSM GPS Bluetooth SIM Quadband features:
- SIM card SIM808 GPRS GSM GPS Bluetooth SIM
- Supply voltage range: 3.4-4.4V
- Four bands GSM 850/900/1800 / 1900MHz
- GPRS multi-slot class 12/10
- GPRS mobile station class B
- According to GSM phase 2/2 +
- Class 4 (2 W at 850/900 MHz)
- Class 1 (1W at 1800 / 1900MHz)
- Control by AT commands (3GPP TS 27.007.27.005 and enhanced AT Commands from SIM Com)
- Operating temperature: -40 to + 85 ° C
- PCB dimension: 38x38mm
- GPS sensitivity
- Tracking: -165dBm Cold start Sensitivity
- Cold start: -147dBm
- Time to first solution
- Cold start: 30 s
- Start to warm up: 28s
- Already hot: 1s - Accuracy

The zirconium ceramic tip of the CD-200/201 combines the wear resistance of a metal tip with the non-conductive and non-inductive properties of the plastic.
Ceramic alignment tool CD-20 features:
- Length: 11.5 cm,
- Screwdriver tip: flat,
- Tip length: 2mm.
- Suitable for: potentiometers, watchmaking, electronics components.

Fan 12V 2x 3D Printer Cables features:
- Voltage: 12V
- Consumption: 65mA
- Speed: 3800rpm -5600rpm - Noise level: 25dB ± 10%
- Screw diameter: 4.5mm
- Service Life Time: 35000 hours
- Operating temperature: -10 ° C to 65 ° C
- Cable length: 11cm
- Dimensions: 40mm x 40mm x 10mm

5 Axis CNC Interface Board Stepper Driver Mach3 USB CNC Cutting Machine features:
- Compatible with MACH3, Linux CNC (EMC2) etc. CNC parallel control software.
- Designed for single axis CNC single phase stepper controller controller:
M542, MA860H, 2M542, DM860 etc.
- Stepper motor controller drivers 5 axis maximum support.
- Wide input voltage range: 12-24V and with anti-reverse function.
- USB power supply and peripheral power phase are separated to protect computer security
- All signals are opto-isolated, which can protect the security of your computer.
- 5 input interface to define limit, emergency stop, cutter alignment, etc.
- A relay output control interface, accessed by spindle motor or air pump, water pump, etc.