Makerbase MKS TFT35 V1.0 touch screen smart display controller 3d printer

12864 LCD Display Full Graphic Intelligent Controller can be connected directly to your RAMPS 1.4. All new operations, such as calibration, axis movement can be done only with the smart rotary encoder. You don't need to use your PC. Just use the design in G-Code stored on the SD card.

Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 2 poles 5.08mm pitch features:
Number of Contacts: 2
Pitch: 5.08mm
Number of Rows: 1
Mounting Type: PCB
Gender: Male
Allowable Section: 1.5mm2 (22- 14 AWG)
Termination method: screw
Type: screw terminal block
Nominal current: 16A
Nominal voltage: 250V
Color: blue
Material: Nylon 66
Depth: 10mm
Width: 7.5mm
Length: 10mm

MKS MOS25 is the Mosfet printer heating module for heated bed that supports current up to 25A. We recommend MKS MOSFET, especially if you are trying to use a heated bed with your 3D printer and 12V power supply.

Mini electricity generator, built base on a turbine and an electric generator that converts kinetic energy into electricity. The generator output is rectified and regulated for a maximum of 12V. Please note -if we want to generate more current, the turbine will oppose the greater resistance to the flow of water, and the voltage may drop if the water flow is not sufficient. This generator is made of plastic and the turbine is totally isolated from the generator and rectifier, the outputs are 1/2 "usually found in domestic pipes.

1m 6mm GT2 strap 3D printer features:
- GT2 rubber strap with fiberglass reinforced
- Length: 1m
- Width: 6mm
- Strap height: 1.38 mm

Mounting Bracket for Nema Engine 17 42mm features:
- Steel bracket for PAP Nema 17 3D printer motor
- Mounting bracket of 42mm L shape alloy steel for The NEMA17 3D Stepper Motor Printer
- Material: Alloy Steel - Size: 5 x 5 x 5cm
- Black Color
- Fit for 42mm Stepper Motor as NEMA17

The integrated mainboard driver MKS-GEN L V1.0 for 3D printer has been developed by Makerbase to optimize existing problems on the open source controller board such as Ramps 1.4.
This product offers more flexible options for users.
MKS-GEN L V1.0 Integrated Controller Compatible with Ramps 1.4/Mega2560 R3 features:
- Mega2560 and Ramps 1.4 are integrated in the board, which avoids the complicated connectors.
- Supports a variety of step-by-step drivers such as A4988, DRV8825, TMC2100 and LV8729, available to change stepper motors and motors that users like.
- Reserve the signal from the external controller, available to connect an external high current driver to drive stepper motors 57 and 86.
se high quality MOSFET, better cooling and more stable.

Power supply module step up with fixed output 5 VDC accepting a maximum current of 2A.
Works with frequency signals up to 1.2 MHz.
Characteristic:
- Input voltage range: 2 - 5 VDC,
- Fixed output voltage: 5 VDC,
- Output accuracy: ± 0.1 V,
- Maximum output current: 2A,
- Ripple at full load: Vpp & lt; 70mV,
- Operating temperatures: -40ºC - + 85ºC,
- PCB size: 17x13mm.