Module L298P DC 2A Motor Management Shield Bluetooth Interface PWM

Module L298P DC 2A Motor Management Shield Bluetooth Interface PWM description

This module, which uses the exclusive L298P chip for driving high-power motors, can directly control two DC motors, with a drive current up to 2A. The motor output uses eight-speed Schottky diodes as protection.
The design of the letter allows you to connect directly to the Arduino UNO R3 for easier use.

Module L298P DC 2A Motor Management Shield Bluetooth Interface PWM features:

- 1 logical step of the input voltage VD: 5 VDC
- Control of the input voltage VS and control by pulse width modulation:
      - VIN input: 6 - 12 VDC
      - PWRIN input: 4.8 - 35 VDC
- Logic current flow: Iss <36m A
- Operation current management: Io <2 A
- Maximum power dissipation 25W (T = 75 ° C)
- Input of the control signal:
      - High voltage level: 2.3V
      - Low voltage level: -0.3V
- Material interface (Hardware): pin terminal 5.00 mm
- Belt clip and can be controlled through the access signal of the front row
- Driver type: L298 dual-power H bridge controller
- Pins D1-D7: direct drive motor
- Compatible with engine speed control in PWM / PLL mode
- Arduino UNO R3 compatible
- Operating temperature: -25 - 130 ° C
- Size: 68x58 mm