Potentiometer B50K linear

Mini ESP8266 ESP12E CH340 WiFi Development
NodeMcu module based on ESP8266 controller and programming in Lua language
NodeMcu it is equipped with 10 GPIO, PWM, I2C, 1-wire and ADC
It works as a standard WiFi 802.11 b / g / n 2.4 GHz
Wemos D1 Mini ESP8266 ESP12E CH340 WiFi Wireless Development features:

- Compatible with Arduino, programming with the Arduino IDE
- Power supply voltage: 5V
- LOGICAL LEVELS: 3.3V
- 11 input / output pins
- 1 ADC (input: 0-3.3V)
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz - Band: 2400 (MHz)
- Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and power management units Integrated

5x L7812 Voltage Regulator 12V 1.5A TO-220 7812 Arduino L7812CV features:
-Type Output: Fixed
-Voltage Output: 12V
-Manufacturer: ST Microelectronics
-Output current: 1.5A
-Max input voltage: 35V
-Input input min.: 5V
-Operational temperature: 0ºC to + 125ºC
-Encapsulated: TO-220
-Polarity: Positive

2 Double Side Prototype PCB Board 6x8cm features:
-Thickness of PCB: 1.6mm
-Material: high quality FR-4 glass fiber PCB
-Presented and numbered on both sides
-Top and bottom are identical copper layers
-Pads grid (pitch) 2.54mm/0.1", hole diameter 0.9mm

Batch of 600 Units 1/4W Resistors Various values Ohm Ω features:
- Each lot contains
(30 x 20 units):
10Ω, 22Ω, 47Ω, 100Ω, 150Ω, 200Ω, 220Ω, 270Ω, 330Ω, 470Ω, 510Ω, 680Ω, 1KΩ, 2KΩ, 2.2KΩ, 3.3KΩ, 4.7KΩ, 5.1KΩ, 6.8KΩ, 10KΩ, 20KΩ, 47KΩ, 51KΩ, 68KΩ, 100KΩ , 220KΩ, 300KΩ, 470KΩ, 680KΩ, 1M
- Tolerance: ± 5%
- Power: 0.25W

WROOM-32 DEVKIT V1 is an ESP32 processor development board with WiFi and Bluetooth (BLE). It is much faster than the ESP8266 processor (NodeMCU and similar), and very easy to use, with 2x15 pins.

Resistances (100 Ohm) with 5% tolerance and 15W power. Cement winding type

Easily convert water level to analog signal
The analog output signal can be read directly on the Arduino board
Characteristic:
- Operating voltage: 3.3V -5 V
- Consumption: less than 20 mA - Sensor type: Analog
- Operating temperature: 10º C -30º C
- Detection area: 40 mm x 16 mm
- Dimensions: 60 mm x 20 mm

It allows removing the solder residues from the tips.
It cleans better and does not cause temperature drops like with sponges.
You do not need extra water to clean the tip.
Easy and effective cleaning at the tip.
Soldering Tip Cleaning Ball features:
- Dimensions: diameter 50mm