Connector Jack 2.1x5.5mm Power Supply DC Male

Yellow Propeller for Micro Motor 3V 5 6V DC DIY Arduino.

Super capacious 9V battery made in Li-ion technology, direct charging possible via micro USB port!

tested capacity - real capacity - min. 500 mAh, battery precharged to max. 30%.

Resistor 4,7K Ohm 5% 0,25W 1/4W features:
- 4.7K Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Alligator clip connectors Red and  Black.

Sensor Module FZ0888 IR Infrared Speed Meter features:
- The FZ0888 encoder module is a device that can help you in the creation of your robotics and automation project, Whether you want to know the speed of a motor or its exact position
- The module has a digital output (DO) which can be connected to your preferred microcontroller.
The operating mode:
- When the sensor is blocked, the DO output is high
- The AO signal is not enabled in this module
- Power supply: 3.3-5V
- Power consumption current 20 mA max
- PCB dimensions: 32 x 14 mm

Mini DC Converter 1.8A Downstream Voltage Regulator 4.7-23V to 1.0-17V features:
- Voltage Drop Module
- Use a multimeter to check the output voltage and adjust the potentiometer
- Small size: 17mm x 11mm
- Input voltage: 4.75-23V
- Output voltage: 1.0-17V
- Current output: 1.8A (peak max. 3A)
- Operating temperature: -40 to + 85 ºC
- Operating frequency: 240kHz
- Conversion efficiency: up to 96%
- Output ripple: 30mV (no-load) - Voltage regulation: ± 2.5%

DC Gear Motor and Tire Wheel for Smart Car Robot features:
- Voltage: 3 to 6 Vdc
- Reduction: 1:48
- Speed without load: 100 RPM to 6Vdc
- No-load current: 90mA to 3Vdc - 180mA to 6Vdc
- Dimensions of the wheel: diameter 65mm - width 26 mm

CNC shield for arduino works as a controller for CNC type milling machines,
3D printers, laser cutters .
CNC Shield Expansion Plate V3 Engraver 3D Printer features:

• 4 compatible sockets for use of A4988 stepper motor controllers (PAP), DRV8825, other compatible
• 4 support axes X, Y, Z, A
• 2 limit switches for each axis (6 in total)