Connector Jack DC Male 2.1x5.5mm Quick Wire Connector

Crocodile Clip 30A 2x75mm Black + Red features:
- Length: 75mm
- Handle length: 38mm
- Isolated
- Quantity: 2 units

Inlet Module Plug Fuse Switch 220V C14 3D Printer features:
- Voltage and current of 10A, 250V AC
- Plug type - 3 pins IEC320 C14
- Color of the red switch
- Diameter holes 40 mm
- Distance between holes 39mm
- Size 47 x 27 mm
- Total size of 58 x 50 x 34 mm

This Cable Shield provides a 3.5mm connector where you can connect a three-electrode sensor cable, allowing you to test and use the MyoWare 2.0 muscle sensor without actually connecting it to your person.

10x Ring Terminals Isolation features:
- M3.5 Cable connector 0.5-1.5 mm2
- Max current 19A
- Isolated
- Quantity: 10 units

Female jack connectors (2.1mm internal and 5.5mm external)  for powering devices such as 12V/ 24V LED strips, CCTV (Cameras), Arduino.  Easy to install, quick connector without screw - Quick Wire Connector.

3x DC PCB Socket Connector 5.5 x 2.1 features:
- Type: DC female jack
- Diameter of the pin: 2,1mm
- Diameter of the connector: 5.5mm
- Quantity: 3 units

MR30PW-M Socket DC supply 3 pins, current rating: 15A, rated voltage: 500V 

Simple breadboard for your MyoWare Muscle Sensor. You can use the provided area of the shield to solder in any custom circuit you can think of. This shield provides 8 x 15 solderable through holes on a standard 0.1" grid.

MyoWare Power Shield is designed to use two standard CR2032 coin cell batteries to power the MyoWare muscle sensor. These will be connected in parallel for extended capacity at a nominal 3.0V.

2x Banana Connector Diameter 4mm Red and Black features:
- Length: 40 mm
- Diameter plug: 4mm
- Quantity: 2 units