Potentiometer B1K Linear

Characteristic: - Cable 15cm long
- Measurements 74x21x 19mm
- Weight: 8 gr. (approx.)
- Stack length max 67mm

2x MOC3020 Optocoupler 400V features:
-Triac Driver Output Optoisolator
-Pack: DIL 6
-Electronic voltage forward: 1.15V
-Trigger LED current: 30mA
-Voltage isolation: 5,300 VAC RMS
-Maximum blocking voltage: 400V
-Temperature of operation: -40°C a + 85°C

COB LEDs are built as a matrix of LEDs, that is, a concentration of LEDs in a silicone coated tablet. The advantages of LED COB: - A luminous performance of up to 120 lumens / watt (twice as much as LED SMD)
- The light intensity is greater without needing to concentrate so much the beam of light
- Greater durability
- Angle of opening up to 160ºC
- Multidirectional light - Mount LED diode on a good heatsink, add some fan, this is necessary because you have to "remove" the heat from the surface of the plate so that the LEDs last longer to place a little thermal silicone in each of the placement centers of the diodes
- The thermal paste increases the thermal transfer between the diode and the metal plate used as circuit

LITHIUM POLYMER BATTERY Battery LIPO 2650mAh 3.7V features:
-Battery type-lithium polymer. - Type of battery terminals- 3 wires. -Voltage of the battery-3.7 V -Capacity of the battery- 2650 mAh. - Embedded PCM security chip (protection against overload, over discharge, short circuit). Dimensions: -Length / depth of the battery- 71 mm -Width / diameter of the battery- 95 mm It has three cables with a 3-pin connector with a separation of 2 mm. Cables: Red: positive. Black: negative. Yellow: thermistor output.

White plastic wheel with silver tone metal support.
It allows a 360° rotation, provides a good resistance to rolling, wheel silently and without problems. Wheels 30mm PP 360° Rotation for Cylindrical Use features:
- Main material: Polypropylene (PP), steel
- Main color: White, silver tone
- Total size: Total height: 45mm / 1.8 "
- Wheel size: 30 x 13mm / 1.2 "x 0.5" (P * A)
- Hole diameter for mounting: 4mm / 0.16 "
- Space between holes: 28 x 22mm / 1.1 "x 0.9" (L * P)
- Size of the top plate: 38 x 32mm / 1.5 "x 1.3" (L * P)

Resistor 20K Ohm 5% 0,25W 1/4W features:
-20 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

The humidity sensor DHT11 comes in a plastic body ideal for mounting on a panel or similar. It uses a capacitive sensor that returns a digital signal with the measurement. DHT11 Temperature and Humidity Sensor features:
- Operating voltage: 3 to 5 VDC
- Humidity measurement range: 20-95% ± 5% accuracy
- Temperature measurement range: 0ºC to 50ºC ± 2º accuracy
- Maximum sampling rate: 2 seconds
- Working current 2.5mA
- Iterfaz 1-wire
- Dimensions: 2.3 x1.2x 0.5cm
- Quantity: 1 unit