Female to Female Cable 3 Pins 3 Colors

USB to DC Charger Cable 2.1/5.5mm features:
- Charger Cable for Arduino Android
- Color: Black
- Length: 120cm

Fan 12V 2x Cable 50x50x15 3D Printer Reprap features:
- Voltage: 12V
- Speed: 7000rpm ± 10%
- Screw diameter: 4.5mm
- Time lifespan: 50,000 hours
- Operating temperature: -10 ° C to 70 ° C
- Cable length: 28cm
- Dimensions: 50mm x 50mm x 10mm

The L293D motor controller allows you to control two DC motors or one stepper motor using Arduino kits. The system allows you to adjust the direction and rotational speed of motors with a current consumption of up to 600 mA and a supply voltage from 4.5 V to 25 V.

WROOM-32 DEVKIT V1 is an ESP32 processor development board with WiFi and Bluetooth (BLE). It is much faster than the ESP8266 processor (NodeMCU and similar), and very easy to use, with 2x15 pins.

WIFI transceiver based on the ESP8266 controller.
It has a microcontroller and 2 GPIO pins to be able to operate autonomously without the need for an external microcontroller. Characteristic: - Voltage of power: 3.3V
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz
- Band: 2400 (MHz)
- Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and integrated power management units
- Output power: 0.15 (W); + 19.5dBm in 802.11b mode
- Consumption in low power mode:

Driver capable of handling up to two high consumption motors.
We can weld 5mm screw terminals (not included), making it easy to connect other gauge cables.

The Limit Switch - Crash Sensor Brick is a sensor module based on the emergency switch, with a simple circuit design and high sensitivity.

This product is a 1 digit screen composed of 7 red LED segments with excellent brightness and features:.
It works with very low current consumption.
The segments of this screen are connected with a common anode point.
LED Display 1-Digit 7-Segment Red Common Anode features:
- Supply voltage of the segments: 3 VDC
- LED color of the segments: red
- Digit length: 14.2mm
- Digit width: 8.1mm
- Pin numbers: 10
- Diameter of pins: 0.51mm
- Step between pins: 2.54mm
- Consumption current per segment: 30mA
- Maximum admissible current per segment: 70mA
- Direct current by segment (pulse operation): 30mA
- Digit numbers: 1
- Segment numbers by digit: 7
- Operating temperature: -25°C - + 85°C