Flat Cable 1m AWG28 1.27 10 Pins Colors

Thermally Conductive Silicone Paste H facilitates the transfer of calories between the electronic components and the radiator.
It is necessary for the correct operation of any type of temperature sensors.

Resistor 220 Ohm 5% 0,25W 1/4W features:
-220 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Tower Pro Micro Servo 9g SG90 features:
- Operating voltage: 3.0-7.2V
- Speed (4.8V without load): 0.12sec / 60 degrees
- Strength: 1.2kg / 42.3oz (4.8V); 1.6 kg / 56.4oz (6.0V)
- Working temperature: -30 to +60 degrees C
- Cable length: approx. 23cm
- Includes photo accessories and screws
- Dimensions: 22x11.5x27mm

This BLtouch sensor is an automatic leveling sensor for 3D printers that can accurately measure the inclination of your printing surface.
It can greatly improve the printing precision of your 3D printer.
Its features: are simple, smart and precise.
It could work with almost any type of bedding, such as glass, wood , metals, etc. 3DTouch's main functions and controls are the same as most automatic bed leveling sensors, consisting of an RC servo and a micro switch.

Self-leveling sensor BLtouch 3D printer features:
- Supply voltage: 5V.
- Supply current: 15mA
- Max. Current: 300mA
- Len3Dh cable: 150mm
- Wiring:
- 3 pins: Brown (-, GND) Red (+ 5V) Orange (control signal)

15x Electrolytic Capacitor 10uF 25V 105ºC PIC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 10uF
-Maximum tension: 25V
-Maximum temperature: 105º C
-Dimensions: 5x11mm
-Quantity: 15 units

1 Channel Relay Module DC 5V 10A Low/High Trigger for Arduino features:
- Channel: 1 (protected with Optocoupler)
- Supply voltage: 5V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- Trigger signal type jumper (low / high)
- LED indicator
- Dimensions: 30x 54mm
- Has a jumper that allows to choose type of trigger signal (low / high)
- This module can be controlled directly by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL)

Level sensor for liquids with float.
The liquid level sensor acts as a switch. The state is changed by means of a magnet located on the float. It can be used to detect liquid levels that are too high or too low.
Ideal for all those applications where it is necessary to control the level of non-corrosive liquids such as water tanks, aquariums.
Characteristic:
- Maximum Load: 50W
- Maximum Switching Voltage: 250V
- Maximum Switching Current: 0.5A
- Maximum charging current: 1A
- Operating temperature: -10ºC to + 60ºC
- Size: 58mm x 18mm

It is a very ideal tool when the third hand is required.
Helping Magnifying Hand Tool features:
- Magnifying glass diameter 60mm
- Weight: 0.5kg
- Dimensions: approx. 15 (26) x 17 x 7cm