Soldering Aid Kit Welding Tools

Encapsulated with water resistant stainless steel with sensor dimensions 5,5 * 50mm, cable length 100 cm.
DS18B20 Submersible Probe Sensor Temperature features:
- Based on the DS18B20 chip
- Supply voltage: 3 ~ 5.5V
- Consumption <5mA
- Measuring Range: -55 °C to 125 °C
- Accuracy: +/- 0,5ºC
- Outputs: - GND black
      - Red Vcc
      - Yellow digital output
- Inocidable steel
- Cable length: 1m

2 Cables for 1M Multimeter Meter features:
- Voltage 1000V, 10A CAT III
- Total length 110cm
- Red and black colors

LED 5mm RGB 4 Pin anode commun with clear water lens.

Tin ideal for application in consumer electronics circuits
Tin Roll 99.3/0.7 Sn/Cu 3% Flux 10g 1mm features:
- 10 gr. welding wire of 1 mm diameter. 99,3% tin, 0,5-0,9% copper and 0,07% lead
- Melting temperature 227 C
- Alloy Sn99Cu1
- Flux 3% Roma IPC-J-STD-004B, SW32 DIN8511  - RohS2 compliant  - Quantity: 1 unit
- High quality - manufactured in EU

The module is based on a touch sensitive IC capacitive touch switch module (TTP223B).
In the normal state, the module produces Low power consumption. When a finger touches the corresponding position, the module output is high, if not touched for 12 seconds, it switches to low power mode. Digital Touch Sensor B21 features:
- Low power consumption
- Input voltage: 2 - 5.5VDC
- Can replace the traditional touch of a button - Four M2 screws diameter 2.2 mm that position the holes for easy installation
- 3-pin control interface:
1- GND
2- VCC
3- Control signal (output pin)
- Power indicators: Bright green LED when the sensor is on

It is used to pass the current, power electrical and electronic circuits, fans, motors, among others. Black Crocodile Clip KK1 with Banana Plug features:
- Total length: 53 mm
- Handle length: 34 mm
- Color: Black
- Banana shot: yes
- Isolated terminals: yes
- Maximum opening: Around 9 mm
- Conductive material: Nickel-plated steel
- Includes 1 unit

MB-102 Prototype Board + 65x Jumper Cable + Power Module 3.3V 5V Arduino features:
* 65 Male-Male jumper cables:
-Cable lengths: 120mm, 150mm, 200mm, 240mm * MB-102 breadboard:
-830 Connections
-Measures 165x55x8 mm
* Module:
-Input voltage up to 12V
-Maximum current 700mA

- Bootloader Pin Header Compatible 100% ARDUINO
- Pro Mini Atmega328P 5v 16Mhz
- Miniaturized compatible version of Arduino Pro Mini
- It has an Atmega328P chip running at 16Mhz with a factory-loaded bootloader. It does not include pins so we can only solder the pins that we need
Characteristic:
- ATmega328P 16MHz chip with external quartz crystal
- Auto-reset - micro switch
- Integrated 5V regulator
- FLASH 32kB memory
- SRAM 1kB memory
- EEPROM 1Kb memory
- Analog input A0-A7
- 8 PWM channels
- External interruption
- TWI / I2C, UART, SPI interfaces
- Power and status LEDs
- Dimensions: 18x33mm
- Weight: 30 grams
Useful links for Arduino />