60/40 Tin Lead Solder Wire Soldering Flux Sn60/Pb40 2.5% 1mm 50g

Ideal to power your Arduino board.
Battery Holder 6x AA with DC Connector 9V LR06 features:
- Cable 12cm long,
- Measures 90x 55x 15mm,
- Max 50mm pile length,
- Compatible batteries (LR06, R06, MN1500, AM3, UM3, HP7).

Polarity cannot be reversed by mistake.
90 degree angle connector. JST PHR-2 Connector Male Angle 3 PIN 2mm features:
Manufacturer JST Connector series: PH Connector: female connector Connector class: male Connector type: conduit-plate Contactor raster: 2mm Number of pins: 3 Electrical mounting: THT Working voltage: 100V Working current: 2A Working temperature: -25 ... 85 ° C Spatial orientation: horizontal data sheet PH series

In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge.

LED 5mm RGB 4 Pins cathode commun with clear water lens.

Soldering Iron 40W features:
- Power: 40W
- Power: 230V
- Equipped with tip B1
- Long length tip: 1mm
- Anti-thermal handle
- CE, RoHS and TUV certifications

- It has an Atmega328P chip running at 16Mhz with factory-loaded bootloader
- The Uno R3 module has all the Arduino Uno R3 connectors and is compatible with all Arduino shields
Characteristic:
- ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATMega328P
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O pins: 14 (6 with PWM)
- Analog input pins: 6
- DC current for Pin I / O: 20 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - AtMega328P
- SRAM 2 KB - AtMega328P
- EEPROM 1 KB - AtMega328P
- Communication: USB female Type B

20 Mini Jumpers 2.54mm Short Circuit Board PCB features:
- Mini standard 2.54mm jumpers for making short circuit bridges on printed circuit boards, hard disks, PCBs, etc.

Support for ultrasounds, HC-SR04 distance meter.
Ideal to install the sensor on mobile platforms such as robots, vehicles, etc. Support for HC-SR04 Ultrasonic Sensor features:
- Material: Acrylic
- Color: transparent
- Includes screws