Linear Axis Support 16mm 3D Printer SK16 SH16 XYZ CNC

Flux Colophony Rosin Core 100g features:
Flux rosin, solid resin, neutral ph for correct electronic welding.
-Does not cause corrosion of non-ferrous metals
-Does not cause short circuits
-It melts with the temperature, spreading through the area to be welded and penetrating into the most difficult corners
-Cleans and prepares the surfaces and components to be welded, and facilitates the adherence and fluidity of the tin, improving welding in electronics works
Use a toothpick for the application. Do not apply in excess.
SECURITY:
-Use in ventilated spaces. Do not inhale vapors that are released when welding
-Keep the pot tightly closed and out of reach of children
-Do not eat. It is not toxic
-Rarely irritating to skin contact

10mm Bore Pillow Block Mounted Bearing is often suited to support rotating shaft applications.

Linear Bearing LM8UU 8mm Ball Bearing for 3D Printer RepRap Prusa features:

- Measurements:
* Internal diameter: 8mm
* External diameter: 15mm
* Length: 24mm
- Enclosure material: anti-corrosion chrome steel
- Inner support material: technical plastic

1.44 inch TFT LCD screen 128x128 SPI features:
- TFT LCD screen 128x128 pixels
- 4-wire SPI interface (A0, SDA, SCK, CS)
- Size: 1.44 inches
- Interface: SPI
- Resolution: 128 * 128
- Visual area: 1: 1 square
- Color screen TFT, the effect is much better than other small CSTN displays
- Disk drive: ST7735
- Fully compatible and alternative 5110 interface
- Onboard LDO, 5V / 3.3 input voltage support V
- Screen dimensions: 30 x 28 mm
- PCB dimensions: 45 x 32 mm

This RAB Holder is not only compatible with Raspberry Pi 3 B+ / Raspberry Pi 3 Model B / 2 Model B / B+, but also suitable for Arduino Uno, Mega2560, 400 Tie-Point and 830 Point breadboards. 

Support for ultrasounds, HC-SR04 distance meter.
Ideal to install the sensor on mobile platforms such as robots, vehicles, etc. Support for HC-SR04 Ultrasonic Sensor features:
- Material: Acrylic
- Color: transparent
- Includes screws

This module includes the BMP280 component that converts atmospheric pressure, temperature and humidity with high precision into a digital signal.
The equipment uses the two I2C and SPI interfaces. The very good measurements made by the BMP280 allows the module to be used as an altimeter.
Its 5-pin straight connector allows easy connection to other electronic boards. BMP280 Temperature Barometric Pressure Sensor Module/SPI features:
- Interfaces:
       -I2C (up to 3.4 MHz)
       -SPI (up to 10 MHz)
- Supply voltage: 1.8-5VDC
- Module operating range:
       - Temperature: -40ºC to + 85ºC
0-100%
       - Pressure: 300-1100 hPa
- Resolution of the measures:
       - Temperature: 0.01ºC

Linear Bearing LM12UU 12mm Ball Bearing for 3D Printer RepRap Prusa features:
- Reprap Prusa 3D Printer
- Measurements:
* Internal diameter 12mm
* External diameter 21mm
* Length 30mm
- Enclosure material: chrome-plated anti-corrosion steel
- Inner support material: technical plastic