Adjustable support for laser diode

USB DC 5V Bluetooth Audio features:
- You can connect it with your smartphone
- Power: DC 5V micro USB
- Speaker: 4 ~ 8 Ohm - Audio Jack: 3.5mm
- SD card: support MP3 / WMA / WAV / FLAC format
- The transmission distance could be up to 10m
- Size: 50 x 40 mm

This module is a three way switch ( COM, NO and NC ) that uses the intensity of the ambient light to control directly the load at the output. Its adjustment potentiometer allows changing the sensitivity and setting the start threshold of the relay. The relay is energized when it is darker than the threshold.

The transfer of heat between the electronic components and the radiator is facilitated.
It is necessary for the correct operation of any type of temperature sensors.
It is characterized by a very good chemical resistance for oxidation, water solutions of acids, alkalis and salts, sulfur dioxide and ammonia. Thermo Conductive Grease Paste 340°C 3D Prusa 100g features:
- It has a very wide range of working temperatures: -30 °C ~ 300 °C
- Maximum momentary working temperature 340 °C
- Thermal conductivity> 1.5 W / mK

Compact instrument that measures the speed of rotation with a visible red light beam from a powerful LED. The high intensity class II laser measures wide measurement range and high resolution, from 2.5 to 99.999 RPM (Revolutions per Minute)

Red Laser Module 650nm 5mW Head Point Adjustable Focal Length features:
- Type: red laser diode
- Laser type: point
- Adjustable Focus
- Wavelength: 650nm
- Output power: 5mW
- Operating voltage: 4.5-5V
- Operating intensity: <40mA
- Operating temperature: -30ºC to 60ºC
- Dimensions of the emitter: Φ12x35mm
- Cable length: 130mm

- Inner diameter: 12mm
- Quantity: 1 unit

Version compatible with Arduino Mega2560 R3
It has an Atmega2560 chip running at 16Mhz with a factory-loaded bootloader
With 54 digital input / output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UART (hardware serial ports)
The board includes a USB connector, an ICSP port , a reset button and some status LEDs
Arduino compatible Mega2560 R3 CH340 board features:

- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Digital I / O Pins: 54 (14 PWM outputs)
- Analog input pins 16
- DC current per I / O Pin 40 mA
- DC Current per Pin 3.3V 50 mA
- Flash: 256 KB of which 8 KB are used by the bootloader
- SRAM: 8 KB
- EEPROM: 4 KB - Clock speed 16 MHz

This module includes the BMP280 component that converts atmospheric pressure, temperature and humidity with high precision into a digital signal.
The equipment uses the two I2C and SPI interfaces. The very good measurements made by the BMP280 allows the module to be used as an altimeter.
Its 5-pin straight connector allows easy connection to other electronic boards. BMP280 Temperature Barometric Pressure Sensor Module/SPI features:
- Interfaces:
       -I2C (up to 3.4 MHz)
       -SPI (up to 10 MHz)
- Supply voltage: 1.8-5VDC
- Module operating range:
       - Temperature: -40ºC to + 85ºC
0-100%
       - Pressure: 300-1100 hPa
- Resolution of the measures:
       - Temperature: 0.01ºC