Support 8mm Linear Axis XYZ CNC 3d Reprap Printer SK8 SH8

CNC shield for arduino works as a controller for CNC type milling machines,
3D printers, laser cutters .
CNC Shield Expansion Plate V3 Engraver 3D Printer features:

• 4 compatible sockets for use of A4988 stepper motor controllers (PAP), DRV8825, other compatible
• 4 support axes X, Y, Z, A
• 2 limit switches for each axis (6 in total)

This BLtouch sensor is an automatic leveling sensor for 3D printers that can accurately measure the inclination of your printing surface.
It can greatly improve the printing precision of your 3D printer.
Its features: are simple, smart and precise.
It could work with almost any type of bedding, such as glass, wood , metals, etc. 3DTouch's main functions and controls are the same as most automatic bed leveling sensors, consisting of an RC servo and a micro switch.

Self-leveling sensor BLtouch 3D printer features:
- Supply voltage: 5V.
- Supply current: 15mA
- Max. Current: 300mA
- Len3Dh cable: 150mm
- Wiring:
- 3 pins: Brown (-, GND) Red (+ 5V) Orange (control signal)

1.44 inch TFT LCD screen 128x128 SPI features:
- TFT LCD screen 128x128 pixels
- 4-wire SPI interface (A0, SDA, SCK, CS)
- Size: 1.44 inches
- Interface: SPI
- Resolution: 128 * 128
- Visual area: 1: 1 square
- Color screen TFT, the effect is much better than other small CSTN displays
- Disk drive: ST7735
- Fully compatible and alternative 5110 interface
- Onboard LDO, 5V / 3.3 input voltage support V
- Screen dimensions: 30 x 28 mm
- PCB dimensions: 45 x 32 mm

SCS12UU is aluminum block shell. LM12UU linear bearing built-in.

It's a slide block for 12mm smooth rods

- Inner diameter: 16mm
- Quantity: 1 unit

RepRap Arduino Mega Pololu Shield (RAMPS) version 1.4 for 3D printer. RAMPS is a shield for the Arduino Mega - The outputs of the Arduino board are redirected to the motor drivers. To have the complete electronics for a 3D printer you need a RAMPS, an Arduino Mega and at least four stepper motor drivers

Fan 12V 2x 3D Printer Cables features:
- Voltage: 12V
- Consumption: 65mA
- Speed: 3800rpm -5600rpm - Noise level: 25dB ± 10%
- Screw diameter: 4.5mm
- Service Life Time: 35000 hours
- Operating temperature: -10 ° C to 65 ° C
- Cable length: 11cm
- Dimensions: 40mm x 40mm x 10mm