Trapezoid Nut 8mm P2 R8 D8

40x Male to male cables 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Dupont male connectors on both ends
- Compatible with 2.54mm female connectors
- High quality and good working condition
- Easy to install and use

Mechanical End of Career CNC Ramps1.4 3D Printer features:
- Mechanical limit switch, Endstop
- 100% brand new and high quality
- 1A 125V AC switch - Cable length: 70cm
- PCB dimensions: 40mm x 15mm

It has an ATMega328P chip running at 16Mhz with a factory loaded bootloader
Characteristic:
- Microcontroller: ATmega328
- Operating Voltage (logic level): 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins: 14 (6 PWM outputs)
- Analog Inputs: 8 (A0-A7)
- DC Current per Pin I / O 40 mA
- Flash Memory: 32 KB (2 KB used by the bootloader)
- SRAM: 2 KB
- EEPROM: 1 KB
- Clock Frequency: 16 MHz
- USB Communication - CH340
- Dimensions: 18 mm x 44 mm

This type of spring nut is suitable only for type B trapezoidal screws with a pitch of 2 mm that give a complete revolution of 8 mm
Anti Backlash Spring Loaded Nut for Trapezoidal Screw L8 features:
- Material: brass and steel spring
- Complete revolution: 8 mm
- Diameter: 22 mm
- Length: 43 mm
- Each anti-rebound nut included large nut, spring and small nut

Filament of ABS material (perfect for basic and fast projects that do not need much durability) for 3D printers. The diameter of the filament is 1.75mm. The kit contains 850g of Graphite filament

3x Heat Sink Aluminium Adhesive A4988 DRV8825 features:
- Package includes: 3x Heatsink with adhesive
- Ideal for DRV8825, A4988 etc
- Dimensions: 9 x 9 x 5mm

28BYJ-48 Stepper Motor 12V + Driver Board ULN2003 features:
- Stepper motor 28BYJ-48 + ULN2003 controller
- The 28BYJ-48 has everything you need to start using motors step by step in your project
- A stepper motor converts digital impulses into small steps of movement in one direction
- The motor also comes with a ULN2003 motor controller card
- Can control two DC motors or a motor with bipolar steps with a maximum amperage of up to 500 mA
- Equipped with state indicator LEDs A, B, C, D
- Engine model: 28BYJ-48
- Phasing Engine: 4
- Operating voltage: 12V DC
- Frequency: 100 Hz
- Operating current: 200mA
- Max Power: 20W
- Winding resistance: 70 Ohm
- Angle per step: 5,625º
- Steps per round: 64

Filament of ABS material (perfect for basic and fast projects that do not need much durability) for 3D printers. The diameter of the filament is 1.75mm. The kit contains 850g of Light Green filament