Linear Bearing LM8UU 8mm Ball Bearing for 3D Printer

Descripción:
Chip XL4015 - Upgrade of the LM2596
Drop module
Use a multimeter to check the output voltage and adjust the potentiometer
Voltage control
XL4015 DC Voltage Converter 5A 75W Step Down Regulator DC LM2596 features:
- Input voltage: 4.5V-38V
- Output voltage: 1.25-36.5V
- Current output: 4.5A (max 5A)
- Output power: 75W maximum
- Operating temperature: -40 to + 85 ºC
- Operating frequency: 180KHz
- Efficiency conversion: up to 96%
- Short circuit protection: Yes (limited current 8A)
- Protection over temperature: the output switches off automatically
- Size: 62mm x 38mm x 15mm
Principal functions:
- Step-down converter with overcurrent protection
- Li-Po battery charger, Li-Ion

Characteristic: - Voltage 24V
- Power 40W
- Material: Ceramic and Stainless Steel
- Cartridge diameter 6 mm - Cartridge length 20 mm
- Cable length approx. 1000 mm

A4988 + RepRap Radiator features:
- Minimum operating voltage: 8 V
- Maximum operating voltage: 35 V
- Maximum current: ± 2 A (adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8, and 1/16
- Factory soldered temples
- Use potentiometer to adjust current
- Measurements: 20x16x12 mm

Connector BLS04 Female / Female 4 Pins RoHS Single Row features:
- Step between pins: 2.54 mm
- Manufacturer: Maritex
- Number of connections: 4 in a single row
- Type: Female / Female
- RoHS standard

- Measurements:
Inner diameter d: 8mm
Outside diameter D: 22mm
Width - dimension B: 7mm
- Dimension C1: 1,5mm
- Dimension D1: 25mm
- Quantity: 1 unit

Touch screen / intelligent controller MKS TFT35 for 3D RepRap printers. The MKS TFT35 is a 3.5 "color touch screen for various RepRap or open source 3D printers. The screen is compatible with MKS boards such as MKS Base, MKS Gen and MKS Mini. It is easy to connect and can be easily used with marlin.It is completely open software and allows any adjustment. To simplify an individual project, various projects can be selected in the standard internal software. In addition, 13 buttons can be freely assigned to activate various functions at the touch of a button. The firmware can be quickly and easily customized using a file on the SD card and can be changed without external programs..

10x Photoresistor 5mm GL5516 LDR 5-10k for Arduino.
Photoresistor is a resistor whose resistance decreases when increasing the intensity of the light that falls on it. 10x Photoresistor GL5516 LDR features:
- Model: GL5516
- Spectral peak: 540nm
- Maximum DC voltage: 150V
- Maximum power: 90mW.
- Resistance with light (10lux): 5-10KΩ
- Resistance with darkness (0lux): 0.5MΩ
- Response time: 20ms
- Operating temperature: -30ºC - 70ºC