Pulley GT2 16 Teeth 6mm Aluminium Pulley 3D Printer Reprap

Flat Cable GPIO 40 Pins M/F features:
- For Raspberry Pi 2 and Pi 3, B and B +
- Total length 20cm
- Quantity: 1 unit

Product Category: Bipolar Transistor, NPN.
BC547B NPN 50V 100mA transistor 0.1A TO-92 features:

- Package / Case: TO-92
- Quantity: 25 units
- Collector-base voltage VCBO: 50V
- Collector-emitter voltage VCEO: 45V
- VEBO emitter-base voltage: 6V
- Continuous collector current: 100mA
- DC MAX collector current: 200mA
- Maximum power dissipation: 500mW

Pulley GT2 36 Teeth 6mm Aluminium Pulley 3D Printer Reprap features:
- Number of teeth: 36
- Pitch: 2mm
- Material: Aluminum alloy
- Outside diameter: 25mm
- Inner hole: 5mm
- Use with strap: 6mm and 6.35mm
- Ideal to fix on the axis of the motors of your 3D printer

Extension Board Shield for Arduino Nano V3.0.

- Measurements:
* Inner diameter D: 5mm
* Outside diameter D: 14mm
* Width - dimension B: 5mm
* Dimension C1: 1mm
* Dimension D1: 16mm
- Quantity: 1 unit

It consists of a display of 16 characters and 4 rows.
Ideal for projects with Arduino.
You can use it with PIC, AVR, STM32. LCD 1604 Display Screen Blue Backlight 16x4 characters features:
- LCD screen, 16 characters and 4 lines
- 5V power
- Backlit green background, white letters
- Include an adjustable contrast pin

Screw Shield V2- Arduino ScrewShield UNO features:
Screw Shield V2 allows: - Being punctured directly to an Arduino Uno
- Facilitate the connection of different modules, such as sensors, relays, servos, buttons, potentiometers and more.

The module uses a 24-bit high precision A/D conversion chip HX711.
The input circuit can be configured to provide a bridge.
The electric bridge voltage sensor model (such as pressure, weight) is an ideal sampling module with high precision and low cost. HX711 Module Weighing Pressure Sensor 24 Bits features:
- Two selectable differential input channels
- Active low noise PGA with selectable gain of 32, 64 and 128
- Power supply regulator for load cell and ADC analog power supply
- Oscillator on chip that does not require external component with optional external glass
- Power-on-reset on the chip
- Simple serial control and serial interface: controls driven by pins, programming is not required
- Output data rate 10SPS or 80SPS selectable