Positive Voltage Regulator TS117B 3.3V 1Amp Low Dropout

The L293D motor controller allows you to control two DC motors or one stepper motor using Arduino kits. The system allows you to adjust the direction and rotational speed of motors with a current consumption of up to 600 mA and a supply voltage from 4.5 V to 25 V.

2x Banana Connector Diameter 4mm Red and Black features:
- Length: 40 mm
- Diameter plug: 4mm
- Quantity: 2 units

The DHT11 humidity sensor is presented in a plastic body ideal for mounting on a panel or similar. It uses a capacitive sensor that returns a digital signal with the measurement.
Characteristic:
- Operating voltage: 3 to 5 VDC - Humidity measurement range: 20-95% ± 5% accuracy
- Temperature measurement range: 0ºC to 50ºC ± 2º accuracy
- Maximum sampling rate: 2 seconds - Working current 2.5mA
- 1-wire interface
- Dimensions: 32 x14 mm
- Quantity: 1 unit with 3x female / female cables

The USB (Universal Serial Bus), is an industrial standard bus that defines the cables, connectors and protocols used in a bus to connect , communicate and supply power between computers, peripherals and electronic devices.
This female type B USB connector adapter soldered on a PCB board is ideal for use in your projects.
It has connection points where you can easily solder some pins to connect it directly to a breadboard, or solder a cable over those same connection points.
USB Type B Female 2.0 Connector Adapter with PCB features:
- Connector type: USB Type B Female,
- Internal color: White,
- Nominal voltage: 30v DC,
- Maximum current: 1A DC,
- Insulation resistance: 1000Mohm,
- Operating temperature: -25ºC to + 85ºC,

Digispark is a development board based on the ATTINY85 microcontroller from ATMEL born in a successful campaign on Kickstarter.
Similar to the Arduino line , It is one of the smallest boards on the market.
Programmable directly from USB with the same Arduino tools. It has a built-in Micronucleus bootloader and can be replaced by similar ones such as the Trinket bootloader. Adafruit or others.
You can use many of the same Arduino libraries and have your own on the digispark wiki. Attiny85 Digispark USB Development Board features:
-USB power supply
-External power supply (7v-35v DC 12v maximum recommended)
-5V DC 500mA regulator on board
-Programmable with the Arduino IDE
-Loaded with Micronucleus bootloader

- It has an Atmega328P chip running at 16Mhz with factory-loaded bootloader
- The Uno R3 module has all the Arduino Uno R3 connectors and is compatible with all Arduino shields
Characteristic:
- ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATMega328P
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O pins: 14 (6 with PWM)
- Analog input pins: 6
- DC current for Pin I / O: 20 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - AtMega328P
- SRAM 2 KB - AtMega328P
- EEPROM 1 KB - AtMega328P
- Communication: USB female Type B

It is used to pass the current, power electrical and electronic circuits, fans, motors, among others. Banana Black Connector Type II ZL15 features:

Soldering Iron 40W features:
- Power: 40W
- Power: 230V
- Equipped with tip B1
- Long length tip: 1mm
- Anti-thermal handle
- CE, RoHS and TUV certifications