78L05 Voltage Regulator 5% 5V 100mA TO-92 WS78L05ACZ
  • 78L05 Voltage Regulator 5% 5V 100mA TO-92 WS78L05ACZ

78L05 Voltage Regulator 5% 5V 100mA TO-92 WS78L05ACZ

T0071

Characteristic:
- Output Type: Fixed
- Voltage Output: 5V
- Manufacturer: ST Microelectronics
- Output Current: 100mA
- Input voltage max.: 30V
- Input voltage min.: 7V
- Operating temperature: 0ºC to + 70ºC
- Encapsulated: TO-92
- Polarity: Positive
- Tolerance output voltage: 5%
- Quantity: 1 unit

OEM
Add to wish list
Spend 100€ to get a 3% discount for all your orders within the next 12 months and even higher discounts for higher spend. Click here to review loyalty program rules

Characteristic:
- Output Type: Fixed
- Voltage Output: 5V
- Manufacturer: ST Microelectronics
- Output Current: 100mA
- Input voltage max.: 30V
- Input voltage min.: 7V
- Operating temperature: 0ºC to + 70ºC
- Encapsulated: TO-92
- Polarity: Positive
- Tolerance output voltage: 5%
- Quantity: 1 unit

Data sheet

Voltaje de entrada
0,1 A
Voltaje de salida
Fijo
Empaquetado
TO-92

Customers who bought this product also bought

20x Zener Diode BZX55C5V1 5.1V 500mW

20x Zener Diode BZX55C5V1 5.1V 500mW features:
-Zerner voltage: 5.1V
-Tolerance: 5%
-Power dissipated: 500mW
-Enter Zener: 35 Ohm
-Configuration: Simple
-Encapsulated: DO-35
-Temperature of work: -65C to 175C
-Quantity: 20 units

T0029

Price €0.08

3S BMS 25A 12.6V 18650 PCM PCB Circuit Charging Module.

In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge.

A0106

Price €3.71

Batch of 600 Units 1/4W Resistors Various values Ohm Ω

Batch of 600 Units 1/4W Resistors Various values Ohm Ω features:
- Each lot contains
(30 x 20 units):
10Ω, 22Ω, 47Ω, 100Ω, 150Ω, 200Ω, 220Ω, 270Ω, 330Ω, 470Ω, 510Ω, 680Ω, 1KΩ, 2KΩ, 2.2KΩ, 3.3KΩ, 4.7KΩ, 5.1KΩ, 6.8KΩ, 10KΩ, 20KΩ, 47KΩ, 51KΩ, 68KΩ, 100KΩ , 220KΩ, 300KΩ, 470KΩ, 680KΩ, 1M
- Tolerance: ± 5%
- Power: 0.25W

D0070

Price €3.26

Thermistor NTC 50.0K 5% MF52A epoxy resin coating resistor

NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance.   Thermistor NTC 50.0K 5% MF52A epoxy resin coating resistor features:

Size: 3mm
Rated resistance: R25 = 50.0k
B value 25/85 = 3950°K
Rated power: ‰¤ 50mW
Tolerance:± 5%
Operating temperature: from -40°C to +125°C  Tinned steel wire 25mm

D0091

Price €0.40

LED 1W Green SMD

Mount LED Diode on a good heatsink, a metal plate, add a fan, this is necessary because you have to "remove" the heat from the surface of the board so that the LEDs last longer to place a little bit of thermal silicone in each of the diode's placement centers.
The thermal paste increases the thermal transfer between the diode and the metal plate used as a circuit.
Important to keep in mind the diodes generate a lot of light intensity and very concentrated.
Avoid looking directly at them once they are turned on and wear protective glasses when working with them. Characteristic: - 30mil chip
- Voltage: 3.0-3.2V
- Current: 300mA
- Luminous flux: 70-80LM
- Ã beam angle: 120 degrees
- Color emission: green

P0046

Price €0.81

Integrated Circuit Supports DIP16 Width 10.16 mm

Integrated Circuit Supports DIP16 Width 10.16 mm features:
- Type: DIP DIL
- Total number of pins: 16
- Step between pins: 2.54 mm
- Material: Polybutylene terephthalate
- Length: 17.78 mm
- Width: 10.16 mm
- Temperature min .: -25 °C
- Max temperature: +85 °C
- RoHS compliant

Z0006

Price €0.12

Thermistor NTC 10.0K 5% MF52A epoxy resin coating resistor

NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance.   Thermistor NTC 10.0K 5% MF52A epoxy resin coating resistor features:

Size: 3mm
Rated resistance: R25 = 10.0k
B value 25/85 = 3950°K
Rated power: ‰¤ 50mW
Tolerance:± 5%
Operating temperature: from -40°C to +125°C  Tinned steel wire 25mm

D0090

Price €0.40

Related articles on blog

No related article on blog

€0.45

0,45 tax excl.

1
12 items
Price €0.45

Order until 4pm we will send today
30 days return