Thermal Pad - 1,5 W/mK - AG Thermopad

LITHIUM POLYMER BATTERY Battery LIPO 2650mAh 3.7V features:
-Battery type-lithium polymer. - Type of battery terminals- 3 wires. -Voltage of the battery-3.7 V -Capacity of the battery- 2650 mAh. - Embedded PCM security chip (protection against overload, over discharge, short circuit). Dimensions: -Length / depth of the battery- 71 mm -Width / diameter of the battery- 95 mm It has three cables with a 3-pin connector with a separation of 2 mm. Cables: Red: positive. Black: negative. Yellow: thermistor output.

2x Female 40-Pin Long Strip features:
- Pin spacing: 2.54mm
- Pin length: 10.5mm
- Insert position: vertical - Insertion: through
- Quantity: 2 units of female strips of 40 pins each

Heat Shrinkable Tube 5 Colors 3 Meters Package features:
- Heat shrink tubing is used to connect electrical cables, isolate resistor and capacitor points, mark and protect cables Electrical, protect metal bars or tubes against corrosion and protect antennas.
- These heat shrink tubes are very flexible and of high quality. Made in EU
- Different sizes of 20 cm each are delivered:
* 1,6mm: black, brown, red, yellow, orange
* 2,4mm: black, brown , red, yellow, blue
* 3,2mm: black, brown, red, yellow, blue
- Quantity: 15 units
- Material: polyolefin
- Shrinkage ratio: 2: 1 (maximum reduce to 1/2 of its supplied diameter)
- Minimum shrinkage temperature: 115 ° C maximum 200 ° C

Gel Battery 12V 7Ah features:

• Long service life - both in cyclic and buffer operation
• No delamination effect from the gelled electrolyte
• It tolerates high operating temperatures well
• It fully recovers to its original capacity from deep discharge

Thermally Conductive Silicone Paste H facilitates the transfer of heat between the electronic components and the radiator. It is necessary for the correct operation of any type of temperature sensors. Global coefficient of heat transfer at 0-150 ° C: 0.88 W / m K

Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 2 poles 5.08mm pitch features:
Number of Contacts: 2
Pitch: 5.08mm
Number of Rows: 1
Mounting Type: PCB
Gender: Male
Allowable Section: 1.5mm2 (22- 14 AWG)
Termination method: screw
Type: screw terminal block
Nominal current: 16A
Nominal voltage: 250V
Color: blue
Material: Nylon 66
Depth: 10mm
Width: 7.5mm
Length: 10mm

Voltmeter Ammeter 100V 50A Digital DC Red Blue features:
- Supply voltage: 4.5V to 30V
- Voltage measurement range: 0V to 100V (± 1%)
- Min voltage resolution: 0.1V
- Current measurement range: 0A to 50A (± 1%)
- Min current resolution: 0.1A
- Operating current: 5mA to 15mA
- Display: Red LED color (Voltage) and Blue LED color (Intensity)
- Includes reverse polarity protection
- Measurement refresh time: 500ms
- Screen dimensions: 48 x 29 mm
- Recessed hole: 45.5 x 26.5 mm
- Depth: 21 mm
- Cable length: 150 mm
- Operating temperature: - 10ºC to 65ºC
- No battery needed
- Dual panel with voltmeter and digital ammeter Useful links for Arduino />

Sensor Module ML8511 UV features:
- The module converts the photocurrent into voltage to detect UV intensity
- The analog voltage is proportional to UV light detecting
- The has a power saving mode of up to 0.1uA, suitable for smart portable devices or mobile phones for use
- Power supply: 5V
- Analog output
- Captured wavelength: 280-390nm
- Ultra low power consumption
- Meteorological applications, skincare, industrial UV level measurement
- Dimensions of PCB: 30x22mm