5m UTP5 Ethernet patch cable

Power Bank 10000 mAh hasta 15 W Joyroom, compatible con tecnologías de carga rápida (PD, QC 3.0, AFC) El Power Bank Joyroom JR-T013 tiene 4 puertos integrados: 1 entrada micro USB, 2 salidas USB y 1 entrada/salida USB C.

Lot of 100unds White Nylon Clamps features:
- Plastic flange, polyamide 100x2.5mm plastic flanges - quantity: 100units

The sensor measures the current flowing in the cable without cutting it. The measurement is made on a single insulated wire, the output is an analog voltage from 0 to 1 V. Sensor SCT-013-030, Non-Invasive 30A AC Current Meter features:
Input current: 0 to 30A AC Output voltage: 0 to 1 V AC Built-in load resistance: 62 Ω Winding ratio: 1800: 1 Operating temperature range: -25 ° C to 70 ° C Cable length: 1 m Sensor weight: approximately 45 g Sensor SCT013-030 datasheet

The network module communicates with the Arduino type board through the SPI protocol ideal for projects with ARDUINO, PIC, AVR, STM32. ENC28J60 Ethernet LAN Network Module for Arduino AVR LPC STM3 features:
- Chip ENC28J60 Microchip
- Module: 10Base-T
- 3.3V power
- SPI interface
- 25Mhz speed
- LED status LED
- Hanrun network transformer
- Network Interface board HR911105A
- Operating temperature: -40ºC to + 85ºC
- Dimensions: 55x 35x 16 mm

Female jack connectors (2.1mm internal and 5.5mm external)  for powering devices such as 12V/ 24V LED strips, CCTV (Cameras), Arduino.  Easy to install, quick connector without screw - Quick Wire Connector.

Mini ESP8266 ESP12E CH340 WiFi Development
NodeMcu module based on ESP8266 controller and programming in Lua language
NodeMcu it is equipped with 10 GPIO, PWM, I2C, 1-wire and ADC
It works as a standard WiFi 802.11 b / g / n 2.4 GHz
Wemos D1 Mini ESP8266 ESP12E CH340 WiFi Wireless Development features:

- Compatible with Arduino, programming with the Arduino IDE
- Power supply voltage: 5V
- LOGICAL LEVELS: 3.3V
- 11 input / output pins
- 1 ADC (input: 0-3.3V)
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz - Band: 2400 (MHz)
- Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and power management units Integrated

3x PCB Circuit Broad Marker Pen for printed circuits features:
-Ideal to write on almost any flat surface, such as PCBs, glass, plastic, metal, etc.
-Resistant to sunlight
-Permanent resistance ink to acid attack
-Quantity: 3 units
S 0.4mm - 1 unit
M 0.6mm- 1 unit
L 1.0mm - 1 unit