Lot of 100unds White Nylon Clamps

- Ideal for use with Reprap Prusa 3D printers & amp; Mendel, with 1m shielded cable
Characteristic:
- Voltage 12V
- Power 40W
- Material: Ceramic y Stainless steel
- Cartridge diameter 6 mm
- Cartridge length 20 mm
- Cable length approx. 1000 mm

The piezoelectric buzzer has a simple structure in which a ceramic piezoelectric disk is affixed to a vibrating plate. An alternative voltage applied to this element will cause a contraction or diametrical expansion of the element. This feature is used to fold a vibrating plate, which generates sounds. 2x Passive Buzzer 5V features:

- Input voltage: 3V to 12V
- Diameter: 12mm
- Height: 7.5mm
- Pin spacing: 6.5mm
- Impedance: 16 Ohm
- Working frequency: 2 to 5 KHz
- Quantity: 1 unit

Cutting Pliers 130mm features:
- This model is not isolated, please use it without current
- Use to cut soft materials, electronic components, cables, plastic card
- Can also be used for welding work

Characteristic: - Supports up to 280ºC
- Electrical and antistatic insulation
- Resistant to acid and alkaline products
- Resistant to solvent
- Adhesive
- Length Approx: 26m
- Known as Kapton polyamide tape
- Product for welding jobs where it is necessary to protect some component from heat

Rocker switch 6A 250VAC / 10A 125VAC ON / OFF 4 pins DPST Double NO contact

Ideal for connecting TTL RS232 devices to your PC through the USB port. PL2303HX PL2303 USB to UART TTL Cable Module RS232 Converter 4 Pin features:
- Compatible controller PL2303HXA
- 4 pins: 5.0V (red), TxR (green), RxD (white), GND (black)
- 2.5A self-recovery protective fuse
- Supported OS: Win8, Win10, WinME, Win2003, Win XP, Vista, Win 7 The 64-bit Prolific drivers provided by Microsoft through Windows Update will not work with most adapters and will therefore generate the generic "Code 10" error.

NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance.   Thermistor NTC 5.0K 5% MF52A epoxy resin coating resistor features:

Size: 3mm
Rated resistance: R25 = 5.0k
B value 25/85 = 3950°K
Rated power: ‰¤ 50mW
Tolerance:± 5%
Operating temperature: from -40°C to +125°C  Tinned steel wire 25mm

The GY-906 BAA is a plate-mounted temperature sensor, based on an integrated 3 V infrared thermometer, single zone, medical precision, compensated gradient, within 3 cm the precision is higher, approximately 0.5 degrees