BME280 Digital Temperature Humidity Barometric Pressure Module This module includes the component BME280 that is translated into a digital signal.The equipment uses the two I2C and SPI interfaces. The BME280 does not allow the module to be used as an altimeter as opposed to its successor BMP280.Its 5-pin straight connector allows easy connection to other electronic boards. BME280 Digital Temperature Humidity Barometric Pressure Module features: - Interfaces:- I2C (up to 3.4 MHz)- SPI (up to 10 MHz)- Supply voltage: 1.8-5VDC- Module operating range:- Temperature: -40ºC to + 85ºC- Humidity: 0-100%- Pressure: 300-1100 hPa- Resolution of the measures:- Temperature: 0.01ºC- Humidity: 0.008%- Pressure: 0. 18Pa- Accuracy of the measures:- Temperature: +/> Code M0135 ✗ Out-of-Stock Regular price €9.88 -€5.00 Price €4.88
CJMCU-717 Series Data Logger This Openlog serial data module is an open source logger that works with a serial connection Simple and supports Micro SD cards up to 64GB. It can store or record huge amounts of serial data and act as a black box. It includes an ATMega328P chip with a high frequency of 16 MHz. All recorded data will be stored on the Micro SD card. Code M0181 Available Price €6.57
Dupont Connector 2.54mm Male Dupont Connector 2.54mm Male features: - Connector for soldering or crimping - Lot 100 units - Ideal for your projects electronic, arduino, but can also be used with other microcontrollers Code K0111 Available Price €1.81
FTDI FT232RL USB-UART Converter - Mini USB FTDI FT232RL USB-UART Converter - Mini USB features: - Serial Converter USB-TTL 3.3V - 5V - LED indicator of Tx, Rx, power. - Communication: TTL COM Virtual RS232 RX / TX Transceiver - Voltage: 3.3V or 5V - per bridge - Pins: DTR, RX, TX, VCC, CTS, GND - Protections: Electronic fuse up to 500mA. - Size: 46 x 19 mm. Step 2.54mm. - Connection: Mini USB - Driver: Windows 7 / 8/10 Linux / Mac / Android - USB TO UART solution with mini USB connector - FT232RL original on board - Compatible with Mac, Linux, Android, WinCE, Windows 7/8 / 8.1 / 10 ... - 3 power mode: 5V output, 3.3V output or powered by the destination board (3.3V-5V) - 3 LEDs: TXD LED, RXD LED, POWER LED - Functional pins Code C0014 Available Price €10.70
40x Female-Female Cable 20cm 40x Female-Female Cable 20cm features: -Length: 20cm -Quantity: 40 wires -Dupont female connectors on both ends -Compatible with 2.54mm male connectors -High quality and good working condition -Easy to install and use Code K0004 Available Price €2.06
5x Push Switch Button B3F Omron Red Key 12mm 5x Push Switch Button B3F Omron Red Key 12mm features:- 5x Push Buttons B3F Omron Key- Maximum current: 50 mA- Tension DC: 24V- Operating force: 1.27N- Switch terminals: weldable- Contact: SPST-NO- Contact resistance: 100M Ohm- Type of action: Superficial- Measures: 12x12x7.3mm Code K0073 Available Price €0.16
40x Female Male 10cm 40x Female Male 10cm features: - Length: 10cm - Quantity: 40 cables - Compatible with 2.54mm male connectors - High quality and good working conditions - Easy to install and use Code K0106 Available Price €1.64
Connector BLS03 Female/Female 3 Pins RoHS Single Row Connector BLS03 Female/Female 3 Pins RoHS Single Row features: - Step between pins: 2.54 mm- Manufacturer: Maritex- Number of connections: 3 in a single row- Type: Female / Female- RoHS standard Code K0119 Available Price €0.08
GPS Module GY-GPS6MV2 NEO6MV2 EEPROM with Antenna It is a mini GPS module including a NEO-6M chip and an EEPROM memory chip. The SMA antenna port is On-board IPEX and cell phone button battery ensure robust positioning efficiency and fast satellite discovery speed. Serial port provides simple initial knowledge to stay in touch with the most compatible Arduino-compatible MCU STM32. Characteristic: - Supply voltage: 3.3 - 5 VDC - Operating current: 45 mA - Communication speed: 9600 Bauds configurable from 4800 to 115200 Bauds - Navigation update: 5 Hz max. (1 Hz default) - Capture time: at the beginning 27s, in operation 1s - Operating temperature: -40 ° C - + 85 ° C - separate GPS antenna 18x18 mm - Size: 22x30x13 mm Code M0071 ✗ Out-of-Stock Price €13.14
USB GPS Receiver with 2m Extension Cable (Compatible with Raspberry Pi/ LattePanda/ Jetson Nano) It is a low-power, high-sensitivity Ublox chip-based GPS receiver module that can receive 56-channel satellite signal. Compared with traditional GPS receivers, it offers much more accurate and faster positioning performance with stronger signals. Integrated with a built-in receiver antenna, this product adopts high-precision positioning chip and industrial grade manufacturing process. Code RA160 ✗ Out-of-Stock Price €14.83
SparkFun GPS Breakout This small GPS breakout is yet another Qwiic module from SparkFun as per usual based on I2C - meaning that you can keep your serial port free for other applications. The board features XA1110 GPS module from GTOP and MediaTek MT3333 chipset already loaded with SparkFun firmware enabling clean and easy use of both ports. Code SP034 Last items in stock Price €54.54
GPS Mini Station NEO-6M-0-001 with EEPROM SMA IPEX Ports It is a mini GPS module including a NEO-6M chip and an EEPROM memory chip. The SMA antenna port is On-board IPEX and cell phone button battery ensure robust positioning efficiency and fast satellite discovery speed. Serial port provides simple initial knowledge to stay in touch with the most compatible Arduino-compatible MCU STM32. Characteristic: - Supply voltage: 3.3 - 5 VDC - Operating current: 45 mA - Communication speed: 9600 Bauds configurable from 4800 to 115200 Bauds - Navigation update: 5 Hz max. (1 Hz default) - Capture time: at the start 27s, in operation 1s - Operating temperature: -40 ° C - + 85 ° C - separate GPS antenna (not included ): 18x18 mm - Size: 22x30x13 mm Code M0070 ✗ Out-of-Stock Price €12.31
GPS Module GY-GPS6MV2 NEO6MV2 EEPROM with Antenna It is a mini GPS module including a NEO-6M chip and an EEPROM memory chip. The SMA antenna port is On-board IPEX and cell phone button battery ensure robust positioning efficiency and fast satellite discovery speed. Serial port provides simple initial knowledge to stay in touch with the most compatible Arduino-compatible MCU STM32. Characteristic: - Supply voltage: 3.3 - 5 VDC - Operating current: 45 mA - Communication speed: 9600 Bauds configurable from 4800 to 115200 Bauds - Navigation update: 5 Hz max. (1 Hz default) - Capture time: at the beginning 27s, in operation 1s - Operating temperature: -40 ° C - + 85 ° C - separate GPS antenna 18x18 mm - Size: 22x30x13 mm Code M0071 ✗ Out-of-Stock Price €13.14
USB GPS Receiver with 2m Extension Cable (Compatible with Raspberry Pi/ LattePanda/ Jetson Nano) It is a low-power, high-sensitivity Ublox chip-based GPS receiver module that can receive 56-channel satellite signal. Compared with traditional GPS receivers, it offers much more accurate and faster positioning performance with stronger signals. Integrated with a built-in receiver antenna, this product adopts high-precision positioning chip and industrial grade manufacturing process. Code RA160 ✗ Out-of-Stock Price €14.83
SparkFun GPS Breakout This small GPS breakout is yet another Qwiic module from SparkFun as per usual based on I2C - meaning that you can keep your serial port free for other applications. The board features XA1110 GPS module from GTOP and MediaTek MT3333 chipset already loaded with SparkFun firmware enabling clean and easy use of both ports. Code SP034 Last items in stock Price €54.54
GPS Mini Station NEO-6M-0-001 with EEPROM SMA IPEX Ports It is a mini GPS module including a NEO-6M chip and an EEPROM memory chip. The SMA antenna port is On-board IPEX and cell phone button battery ensure robust positioning efficiency and fast satellite discovery speed. Serial port provides simple initial knowledge to stay in touch with the most compatible Arduino-compatible MCU STM32. Characteristic: - Supply voltage: 3.3 - 5 VDC - Operating current: 45 mA - Communication speed: 9600 Bauds configurable from 4800 to 115200 Bauds - Navigation update: 5 Hz max. (1 Hz default) - Capture time: at the start 27s, in operation 1s - Operating temperature: -40 ° C - + 85 ° C - separate GPS antenna (not included ): 18x18 mm - Size: 22x30x13 mm Code M0070 ✗ Out-of-Stock Price €12.31