Mini plastic box

It can be used to demagnetize tools or parts that you do not want to magnetize. Especially for magnetizing screwdriver bits or almost anything else. No batteries or electricity required, portable and easy to use.

Rechargeable battery 9V 6F22 Ni-MH 250 mAh Ready to Use features:

Addressable 5050 RGB LED bar (5mm x 5mm) with low current draw. LEDs can be joined by connecting the output of one module to the input of another.
Data line with a very specific protocol, requires a real-time microcontroller AVR, Arduino, PIC, mbed, etc. A minimum 8 MHz processor is required.

The module is based on a touch sensitive IC capacitive touch switch module (TTP223B).
In the normal state, the module produces Low power consumption. When a finger touches the corresponding position, the module output is high, if not touched for 12 seconds, it switches to low power mode. Digital Touch Sensor B21 features:
- Low power consumption
- Input voltage: 2 - 5.5VDC
- Can replace the traditional touch of a button - Four M2 screws diameter 2.2 mm that position the holes for easy installation
- 3-pin control interface:
1- GND
2- VCC
3- Control signal (output pin)
- Power indicators: Bright green LED when the sensor is on

Store and transport your components in the most orderly and safe way with this organiser case. The case is made of sturdy material, has good fastenings and a handle.

The mini magnetic screwdriver 2in1 is a double Phillips and flathead screwdriver. The 2in1 multitool is a practical tool for screwdriving and screw removal. The 2in1 screwdriver will come in handy for every DIY enthusiast, electronics technician and mechanic in the workshop when working.

Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32. MPU-6050 Accelerometer Module + Gyroscope 3 features:
- Chip: MPU-6050
- Power supply: 3V-5V
- Operating current: 5mA
- Communication: I2C
- 16-bit analog-digital converter on all axes
- Gyroscope scales: ± 250, ± 500, ± 1000 and ± 2000 ° / sec (dps) (programmable by the user)
- Accelerometer scales: ± 2g, ± 4g, ± 8g and ± 16g (programmable by the user)
- Dimensions: 14 x 21 x 1.3mm
- Quantity: 1 unit (1 strip of 8 pin + 1 strip of 8 layered pin)

- The DHT22 humidity sensor is presented in a plastic body ideal for mounting on a panel or similar. It uses a capacitive sensor that returns a digital signal with the measurement - This sensor, unlike DHT11, is capable of measuring negative temperature values ​​and measures tenths of a degree
Characteristic:
- Operating voltage: 3 to 5.5 VDC - Humidity measurement range: 0-100% ± 2% accuracy
- Temperature measurement range: -40ºC to 80ºC ± 0.5º accuracy
- Maximum sampling rate: 2 seconds
Useful links for Arduino / Raspberry programming and projects with Arduino / Raspberry boards:
Write texts on the OLED 0.96 '' screen
- Read the measurements of the temperature / humidity sensor DHT22 / AM2302 on a 0.96 '' OLED screen
Send />