20x Electrolytic Capacitor 47uF 50V 105ºC PIC for Arduino

Characteristic:
-10k OHM kΩ - linear potentiometer 10k Arduino
-Tolerance: +/- 20%
- Power: 0.125W

Voltage Sensor Module 0.02445V ~ 25V.
When the module is powered by 5V voltage detection It does not exceed 25V, and when the module is powered with 3.3V the voltage detection does not exceed 16.5V.
100% Compatible with Arduino.
DC voltage sensor 0-25v for Arduino features:

- Input voltage: 0-25 VDC
- Voltage detection range: 0.02445V-25 VDC
- Analog voltage resolution: 0.00489 V
- DC input connector: cathode terminal connected to VCC, GND negative pole
- Output interface: "+" then 5 / 3.3V, "-" then GND, "s" then the Arduino AD pins

Mosfet 24V 5A IRF520 PWM controller features:
- The IRF520 controller module can control the PWM signal from the Arduino module and adjust the DC voltage of So that we can control the speed of the DC motor, the brightness of the bulb, the LEDs, the heater.
- The built-in IRF520 N-MOSFET transistor
- Operating voltage: 3.3V -5V ( compatible with ARDUINO Raspberry PI)
- Charging voltage: 0-24V
- Charging current: up to 5A (more than 1A, the system must be equipped with a heat sink point)
- 60W max power (more than 10W must be equipped with a heat sink)
- Terminalblock connectors
- LED indicating the presence of power
- Dimensions: 33x24mm

5x Electrolytic Capacitor 1000uF 35V 105ºC PIC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 1000uF
-Maximum tension: 35V
-Maximum temperature 105º C
-Dimensions: 13x21mm
-Quantity: 5 units

Protoboard Breadboard 5x7cm features:
-PCB dimension: 5x7cm
-Hole diameter: 1mm
-Pitch: 2.54mm
-Bakelite with copper fields

10x Electrolytic Capacitor 470uF 16V 105ºC PIC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 470uF
-Maximum tension: 16V
-Maximum temperature 105º C
-Dimensions: 8x12mm
-Quantity: 10 units

Heat Shrinkable Tube 5 Colors 3 Meters Package features:
- Heat shrink tubing is used to connect electrical cables, isolate resistor and capacitor points, mark and protect cables Electrical, protect metal bars or tubes against corrosion and protect antennas.
- These heat shrink tubes are very flexible and of high quality. Made in EU
- Different sizes of 20 cm each are delivered:
* 1,6mm: black, brown, red, yellow, orange
* 2,4mm: black, brown , red, yellow, blue
* 3,2mm: black, brown, red, yellow, blue
- Quantity: 15 units
- Material: polyolefin
- Shrinkage ratio: 2: 1 (maximum reduce to 1/2 of its supplied diameter)
- Minimum shrinkage temperature: 115 ° C maximum 200 ° C