Resistor 10M Ohm 5% 0,25W 1/4W

Barometric Pressure, Temperature and Altitude Sensor BMP180 features:
- Module based on the atmospheric pressure sensor BMP180
- Supply voltage: 1.8 - 3.6 V
- Energy consumption: 0.5uA
- I2C interface
- Measuring range: 300 - 1100hPa
- Dimensions: 10 x 13 mm
- Includes soldering pins

10x Electrolytic Capacitor 470uF 16V 105ºC PIC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 470uF
-Maximum tension: 16V
-Maximum temperature 105º C
-Dimensions: 8x12mm
-Quantity: 10 units

IIC/I2C adapter PCF8574 LCD 1602 1604 2004 Interface features:
- Based on the PCF8574A chip
- Power: 5V
- Supports I2C Protocol
- A potentiometer for regulate contrast
- Dimensions: 19x42mm PCF8574 - & gt; the default address 0x20
PCF8574A - & gt; the default address 0x3F - You can change anyone between 0x20 and 0x27 depending on whether or not you have soldered pins A0 A1 A2 - With this module the communication between the Arduino and the LCD It is only made through two outputs, SDA and SCL
- Up to 8 LCD screens can be connected to the same I2C bus choosing a different address - Ideal for projects with ARDUINO and Raspberry Pi platforms - You can use it with PIC, AVR, STM32

Switch Button 8x8mm on-off features:
- Switch terminals: Weldable
- Measures: 8x8x13mm

Tower Pro Micro Servo 9g SG90 360 degree features:
- Operating voltage: 3.0-7.2V
- Speed (4.8V without load): 0.12sec / 60 degrees
- Strength: 1.2kg / 42.3oz (4.8V); 1.6 kg / 56.4oz (6.0V)
- Working temperature: -30 to +60 degrees C
- Cable length: approx. 23cm
- Includes photo accessories and screws
- Dimensions: 22x11.5x27mm

The L293D motor controller allows you to control two DC motors or one stepper motor using Arduino kits. The system allows you to adjust the direction and rotational speed of motors with a current consumption of up to 600 mA and a supply voltage from 4.5 V to 25 V.

Resistor 680K Ohm 5% 0,25W 1/4W features:
-680 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm