MPU-6050 Accelerometer Module + Gyroscope 3

It facilitates the transfer of calories between the electronic components and the radiator.
It is necessary for the correct operation of any type of temperature sensors.
The technology of oxidation, solutions in water of acids, alkalis and sales, sulfur dioxide and ammonia. It has a very wide range of working temperatures. High quality - manufactured in EU Thermal Silicone Paste Heatsink Temperature 100g features:
- Density at 20 °C: 2.58 G / cm3
- Flash point: 350 °C
- Freezing point: -50 °C
- Refractive coefficient: 1.405
- Specific heat at 50 ° C: 0.243 Cal / g K
- Global coefficient of heat transfer at 0-150°C: 0.88 W / m K
- Dielectric constant at 100 Hz: 4.7 (± 0.1)
- Cross resistance: 5 x 10 to the power 14 Ohm x cm

Tower Pro Micro Servo 9g SG90 360 degree features:
- Operating voltage: 3.0-7.2V
- Speed (4.8V without load): 0.12sec / 60 degrees
- Strength: 1.2kg / 42.3oz (4.8V); 1.6 kg / 56.4oz (6.0V)
- Working temperature: -30 to +60 degrees C
- Cable length: approx. 23cm
- Includes photo accessories and screws
- Dimensions: 22x11.5x27mm

WROOM-32 DEVKIT V1 is an ESP32 processor development board with WiFi and Bluetooth (BLE). It is much faster than the ESP8266 processor (NodeMCU and similar), and very easy to use, with 2x15 pins.

10x Female-Male Cables 20cm Jumpers Dupont features:
-Length: 20cm
-Quantity: 10 cables
-Connectors have male and female header contacts at either end
-Compatible with male and female connectors 2,54mm
-High quality and good working conditions
-Easy to install and use

Adjustable Module Buck Converter DC 3A 1,6-26V MP1584 Step-Up Down features:
- Based on the MP1584EN regulator
- Output Voltage: 1.6V - 26V DC (adjustable)
- Input Voltage: 4.5V - 28V DC
- Max. Output Current: 3A (with heat sink)
- Frequency: 1MHz
- Conversion Efficiency (1A): 94%
- Short circuit protection
- Protection against overheating
- Operating temperature: -40ºC to + 85ºC
- Measures 22 x 17 x 4 mm

WIFI transceiver based on the ESP8266 controller.
It has a microcontroller and 2 GPIO pins to be able to operate autonomously without the need for an external microcontroller. Characteristic: - Voltage of power: 3.3V
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz
- Band: 2400 (MHz)
- Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and integrated power management units
- Output power: 0.15 (W); + 19.5dBm in 802.11b mode
- Consumption in low power mode:

Photoresistor is a resistor whose resistance decreases with increasing intensity of light
that affects her 10x Photoresistor GL5528 LDR features:
- Model: GL5528
- Spectral peak: 540nm
- Maximum DC voltage: 150V
- Maximum power: 100mW
- Resistance with light (10lux): 10-20KΩ
- Resistance with darkness (0lux): 1MΩ
- Response time: 20ms
- Operating temperature: -30ºC - 70ºC
- 10k - 20k Arduino PiC 5mm
- Quantity: 10 units

Female Strip 40 Short Pins features:
- Pin spacing: 2.54mm
- Insert position: Vertical
- Insert: Pasante
- Quantity: 1 unit of strips of 40 female pins each