5x Electrolytic Capacitor 2200uF 25V 105ºC PIC for Arduino

Double Side Prototype Board PCB 8x12cm features:
-Thickness of PCB: 1.6mm
-Material: high quality FR-4 glass fiber PCB
-Presented and numbered on both sides
-Top and bottom are identical copper layers
-Pads grid (pitch) 2.54mm/0.1", hole diameter 0.9mm

Sensor used to measure the current in the circuit to which it is connected. Characteristic: - Output: Analog
- Power: 5V
- Accuracy: 1.5%
- Measuring capacity: +/- 30A
- Dimensions: 31 x 13 mm

Protoboard Breadboard 5x7cm features:
-PCB dimension: 5x7cm
-Hole diameter: 1mm
-Pitch: 2.54mm
-Bakelite with copper fields

Camera module for Arduino, Raspberry Pi 2 and Pi 3, B and B +. VGA camera 640x480 OV7670 B 0.3MPx 30fps Cmos features:
> - Input voltage 2.5V-3V
- Operating power 60mW / 15fps VGA YUV
- Resolution VGA 640x480 pixels (30fps)
- Maximum frame rate 30fps VGA
- Flicker 50Hz / 60Hz automatic detection
- Lens size 1/6 "
- Angle of view 25 °
- Sensitivity 1.3V / (lux- seg)
- SCCB (Serial Camera Control Bus) interface
- Output format · 8 Bits
- YUV / YCbCr 4: 2: 2
- RGB 565/555/444
- GRB 4: 2: 2
- RAW RGB data
- High sensitivity Light operation
- Automatic adjustment
- Color level saturation - Edge enhancement
- Noise level

It allows removing the solder residues from the tips.
It cleans better and does not cause temperature drops like with sponges.
You do not need extra water to clean the tip.
Easy and effective cleaning at the tip.
Soldering Tip Cleaning Ball features:
- Dimensions: diameter 50mm

It has an Atmega328P chip running at 16Mhz with a factory loaded bootloader.
The Uno R3 module has all connectors than the Arduino Uno R3 and is compatible with all Arduino shields.
Plate UNO R3 CH340 + Arduino compatible switches features:

- ATmega328P chip at 16MHz with crystal external quartz
- ATmega328P microprocessor with socket
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6- 20V
- Clock speed: 16 MHz
- Digital I / O Pins: 14
- Analog input pins: 6
- DC current per I / O Pin: 40 mA
- DC Current per Pin 3.3V: 50 mA
- Flash32 KB of which 0.5 KB are used by the bootloader -Atmega328
- SRAM 2 KB - Atmega328

Tin ideal for application in consumer electronics circuits
Tin Roll 60/40 Sn/Pb 2.5% Flux 10g 1mm features:
- 16 gr. welding wire of 1 mm diameter. 60% tin, 40% lead
- Melting temperature 187/190 C
- Alloy Sn60Pb40
- Flux 2.5% SW26 1.1.2B ISO9454 - It is leaded alloy for manual and automatic processes where meeting the requirements of the RoHS2 Directive is not required.  - Quantity: 1 unit
- High quality - manufactured in EU

40x Male to male cables 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Dupont male connectors on both ends
- Compatible with 2.54mm female connectors
- High quality and good working condition
- Easy to install and use