Alcohol PCB Cleaner 1l

Ideal for projects with ARDUINO, PIC, AVR, Raspberry
The infrared receiver receives the signal of 38kHz for remote control

USB adapter that allows a direct USB connection to your ESP8266 ESP-01 or ESP-01S WiFi module. Based on the CH340 integrated circuit, which is a USB - Serial converter (UART).

- It has an Atmega328P chip running at 16Mhz with factory-loaded bootloader
- The Uno R3 module has all the Arduino Uno R3 connectors and is compatible with all Arduino shields
Characteristic:
- ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATMega328P
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O pins: 14 (6 with PWM)
- Analog input pins: 6
- DC current for Pin I / O: 20 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - AtMega328P
- SRAM 2 KB - AtMega328P
- EEPROM 1 KB - AtMega328P
- Communication: USB female Type B

Heat Shrinkable Tube 5 Colors 3 Meters Package features:
- Heat shrink tubing is used to connect electrical cables, isolate resistor and capacitor points, mark and protect cables Electrical, protect metal bars or tubes against corrosion and protect antennas.
- These heat shrink tubes are very flexible and of high quality. Made in EU
- Different sizes of 20 cm each are delivered:
* 1,6mm: black, brown, red, yellow, orange
* 2,4mm: black, brown , red, yellow, blue
* 3,2mm: black, brown, red, yellow, blue
- Quantity: 15 units
- Material: polyolefin
- Shrinkage ratio: 2: 1 (maximum reduce to 1/2 of its supplied diameter)
- Minimum shrinkage temperature: 115 ° C maximum 200 ° C

The PCB PLUS cleaner is designed for printed circuit boards.
Dissolves waste flux, including resin.
The liquid does not attack the substrate or the structural components of the printed circuit boards.
The special brush to remove particles and smaller debris. Perfect for cleaning PCB after repair and assembly.
PCB Plus Cleanser Spray 400ml features:
- Form: spray
- Capacity: 400ml
Application:
- The product does not leave deposits
- It evaporates very fast
- Eliminates waste after welding
- Perfect in any electronic service
- The product does not react with most plastics used in electronics

This module is a three way switch ( COM, NO and NC ) that uses the intensity of the ambient light to control directly the load at the output. Its adjustment potentiometer allows changing the sensitivity and setting the start threshold of the relay. The relay is energized when it is darker than the threshold.

Use the right tool for every need.
It is a special electrostatic brush for cleaning electronic components or places where the electrostatic charge must be taken into account. Electrostatic Brush ZD-155C 150 mm features:
- Model: ZD-155C
- Brush length: 150 mm
- Hair length: 16 mm
- Number of hair groups: 3

High grade in the absorption of tin for professionals.
Copper mesh roll for desoldering electronic components.
Desoldering Wire 0.5mm features:
- Material: Copper
- Length: 1.5m
- Width: 0.5mm