Tin Roll 99.3/0.7 Sn/Cu 3% Flux 10g 1mm

Characteristic: -Conductor: flexible copper
-Insulation: PVC
-Low voltage electrical cables
-Standard: EN 50525-2-31
-Number of conductors: 1x0.75mm2
-Resistance at 20ºC: 26.0 Ohm / Km
-Weight (Kg / Km): 12
-Outside diameter: 2.7mm

-Length 1m

Learn how to weld in the most fun and useful way with this luminous Christmas tree. Follow our practical and simple guide step by step, and decorate your home with this flashing Christmas tree. Soldering is an essential technique in electronics and what better way to learn than with this specially prepared kit. 

Its 7 colour RGB LEDs change colour and flash, illuminating any surface in an innovative way for Christmas.

NodeMcu module based on ESP8266 controller and programming in Lua language
NodeMcu is equipped with 10 GPIO, PWM, I2C, 1-wire and ADC
ESP8266-12E is an improved version of ESP8266-12
It works as a standard WiFi 802.11 b / g / n 2.4 GHz
USB Communication - CP2102 Chip
Characteristic:
ESP 12E ESP8266 ESP12E NodeMcu Lua Wireless Development Board CP2102 WiFi features:

- Supply voltage: 3.3V (LOGICAL LEVELS: 3.3V)
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz
- Band: 2400 (MHz) - Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and integrated power management units
- Output power: 0 , 15 (W); + 19.5dBm in 802.11b mode

The ideal tin for application in consumer electronics circuits, especially mobile phones and tablets. 3g of 0.3mm diameter tin wire. Consists of 60% tin, 40% lead. 

Protoboard Breadboard 5x7cm features:
-PCB dimension: 5x7cm
-Hole diameter: 1mm
-Pitch: 2.54mm
-Bakelite with copper fields

It has an ON / OFF switch that will cut off the power when you don't need it and a blue LED indicator light for the power (ON switch). Characteristic: - Color: Black
- Length: 70 cm
- Current max 1A

Device to measure the power consumption of any device powered by USB: phones, chargers, USB disks, consoles, tablets.
The voltage and current are shown successively.
Current and Voltage Meter Tester features:
- Operating range:
       - Voltage 3 - 7,5V
       - Current 0 -3A
- Resolution: 10mV 1mA
- Error: <± 1.5%%
- Dimensions: 5.2 x 2 x 1.5 cm

It allows controlling up to 2 direct current motors or a bipolar stepper motor. It also allows to control a unipolar stepper motor configured as bipolar.
Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32.
L298N Motor Drive Controller Board Module Dual H Bridge DC features:
- Minimum operating voltage: 5 V
- Maximum operating voltage: 35 V
- Maximum current: ± 2 A
- Logic voltage: 5V
- PWM signal inputs for speed control
- Outputs: for 2 DC motors or for a bipolar stepper motor
- Measures: 43x43x24 mm
Helpful Links:
Operation of the robot by Infrared / Operation of the robot by Bluetooth / Automatic operation with detection of obstacles