Laminated Copper Clad Prototype PCB Circuit Board kit pack 10 pcs.

Bridge Rectifier KBL10 - 4A/1000V features:
- Maximum reverse voltage: 1000 V
- Vf - Front tension: 1.0 V
- Max. Overvoltage current: 200 A
- Minimum operating temperature: - 50 C
- Maximum operating temperature: + 150 C
- Go - Reverse current: 10 uA
- Quantity: 1 unit

Protoboard Breadboard 5x7cm features:
-PCB dimension: 5x7cm
-Hole diameter: 1mm
-Pitch: 2.54mm
-Bakelite with copper fields

Batch of 600 Units 1/4W Resistors Various values Ohm Ω features:
- Each lot contains
(30 x 20 units):
10Ω, 22Ω, 47Ω, 100Ω, 150Ω, 200Ω, 220Ω, 270Ω, 330Ω, 470Ω, 510Ω, 680Ω, 1KΩ, 2KΩ, 2.2KΩ, 3.3KΩ, 4.7KΩ, 5.1KΩ, 6.8KΩ, 10KΩ, 20KΩ, 47KΩ, 51KΩ, 68KΩ, 100KΩ , 220KΩ, 300KΩ, 470KΩ, 680KΩ, 1M
- Tolerance: ± 5%
- Power: 0.25W

Mount LED Diode on a good heatsink, a metal plate, add a fan, this is necessary because you have to "remove" the heat from the surface of the board so that the LEDs last longer to place a little bit of thermal silicone in each of the diode's placement centers.
The thermal paste increases the thermal transfer between the diode and the metal plate used as a circuit.
Important to keep in mind the diodes generate a lot of light intensity and very concentrated.
Avoid looking directly at them once they are turned on and wear protective glasses when working with them. Characteristic: - 30mil chip
- Voltage: 3.0-3.2V
- Current: 300mA
- Luminous flux: 70-80LM
- Ã beam angle: 120 degrees
- Color emission: green

Detects changes in the sensor angle and returns to the digital value. 5x SW-520D Vibration Metal Tilt Sensor features:
- Contact resistance:

NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance.   Thermistor NTC 50.0K 5% MF52A epoxy resin coating resistor features:

Size: 3mm
Rated resistance: R25 = 50.0k
B value 25/85 = 3950°K
Rated power: ‰¤ 50mW
Tolerance:± 5%
Operating temperature: from -40°C to +125°C  Tinned steel wire 25mm