10x Strip 6 Pin Female Short

It can be used to control the microprocessor of the Arduino AVR PIC system and others, or as a digital potentiometer rotating the rotary encoder can be counted in positive and negative, depending on the direction of rotation; with the button of the rotary encoder can be reset to its initial state, which starts counting from 0.

Product Category: Bipolar Transistor, NPN.
2N2222 NPN 40V 800mA 300MHz transistor features:

- Package / Case: TO-92
- Quantity: 20 units
- Collector-base voltage VCBO: 75V
- Collector-emitter voltage VCEO: 40V
- VEBO emitter-base voltage: 6V
- Continuous collector current: 600mA
- DC MAX collector current: 800mA
- Maximum power dissipation: 1.6W

Ideal for your electronic projects, Arduino, but can also be used with other microcontrollers.

PAM8403 2x3W Digital Amplifier Channel Stereo features:
- Up to 3W in each channel
- Chip: PAM8403
- Power supply: 5V
- Power: 2 outputs of 3 watts each
- Measures: 21x18 mm
- Suitable impedance speakers: 4 Ohm

- It consists of a 20-character, 4-row display
- The display is compatible with the controller HD44780 and integrates the module so you can use it through the I2C protocol without any problem
- Only two pins are needed for communication, SDA and SCL
- Ideal for projects with ARDUINO and Raspberry Pi platforms - You can use it with PIC, AVR, STM32
PCF8574 - & gt; the default address 0x20
PCF8574A - & gt; the default address 0x3F
- It can be changed to any between 0x20 and 0x27 depending on whether or not you have soldered pins A0 A1 A2
20x4 2004 LCD display PCF8574T I2C Backlit Blue features:

- LCD screen, 20 characters and 4 lines
- 5V power supply
- HD44780 compatible controller

IIC/I2C adapter PCF8574 LCD 1602 1604 2004 Interface features:
- Based on the PCF8574A chip
- Power: 5V
- Supports I2C Protocol
- A potentiometer for regulate contrast
- Dimensions: 19x42mm PCF8574 - & gt; the default address 0x20
PCF8574A - & gt; the default address 0x3F - You can change anyone between 0x20 and 0x27 depending on whether or not you have soldered pins A0 A1 A2 - With this module the communication between the Arduino and the LCD It is only made through two outputs, SDA and SCL
- Up to 8 LCD screens can be connected to the same I2C bus choosing a different address - Ideal for projects with ARDUINO and Raspberry Pi platforms - You can use it with PIC, AVR, STM32

Encapsulated with water resistant stainless steel with sensor dimensions 5.5*50mm, cable length 200 cm. DS18B20 Probe 2m Submersible Temperature Sensor features:
- Based on the DS18B20 chip
- Supply voltage: 3 ~ 5.5V
- Consumption <5mA
- Measuring Range: -55 °C to 125 °C
- Accuracy: +/- 0,5ºC
- Outputs: - GND black
      - Vcc red
      - Yellow digital output
- Inocidable steel
- Cable length: 2m  

40x Female Male 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Compatible with 2.54mm male connectors
- High quality and good working conditions
- Easy to install and use