Switch Button 8x8mm on-off

Micro Servo Compatible with MG90S features:
- Operating voltage: 4.8Vdc (5V) or 6Vdc
- Torque: 1.80 kg / cm at 4.8V and 2.20kg / cm at 6V
- Speed: 0.1seconds / 60º at 4.8V and 0.8 seconds / 60º at 6V
- Gear type: metallic
- Turning width: 180º
- Temperature working: from -30 to 60 ºC
- 3 plastic propellers / arms
- Fixing screws
- Size: 22.6 x 11.8 x 31 mm
- Weight: 13.4 gr

10mm copper tape - Conductor features:
- Material: copper foil - Size: 10 mm — 30 m - Copper foil thickness: 0.05 mm - Conductive - Adhesive - Approx Length: 30m Applications:
- EMI and RF shielding, - paper circuits, soldering, - electrical repairs, - slug repellent.

The 908S 80W soldering iron has a power of 80W equipped with the 900M-B1.2 tip, LCD display to show the temperature setting (180 ~ 500 ℃). Fast heating. The tip is replaceable. The soldering iron is CE, RoHS certified. The kit includes 5 replacement tips and a welding holder.

10x 8-Pin Long Female Strip features:
- Pin spacing: 2.54mm
- Pin length: 10.5mm - Insertion position: Vertical
- Insertion: Through
- Quantity: 10 units of 8-pin female strips each

The module is based on a touch sensitive IC capacitive touch switch module (TTP223B).
In the normal state, the module produces Low power consumption. When a finger touches the corresponding position, the module output is high, if not touched for 12 seconds, it switches to low power mode. Digital Touch Sensor B21 features:
- Low power consumption
- Input voltage: 2 - 5.5VDC
- Can replace the traditional touch of a button - Four M2 screws diameter 2.2 mm that position the holes for easy installation
- 3-pin control interface:
1- GND
2- VCC
3- Control signal (output pin)
- Power indicators: Bright green LED when the sensor is on

The resistance of the sensor has a force measurement range of 0-10 kg
Its resistance varies depending on how much pressure is applied to the detection area, the greater the force, the lower the resistance.
Peel and stick the rubber backing on the other side of the detection area to mount.
It can detect the applied force in the detection area in the range of 0g-10kg.
Circular force sensing resistor features:
- Detection area: 1.27cm / 0.5 inches
- Output signal: passive variable resistance
- Force detection range: 0 g ~ 10 kg
- Length: 6 cm / 2.36 inches
- Width: 1.9cm / 0.75 inches

Push button 6x6x4mm features:
-Touch Push Tact Switch mini electronic Arduino push button
-Measures: 6x6x4.3mm
-Quantity: 1 unit

Characteristic:
-10k OHM kΩ - linear potentiometer 10k Arduino
-Tolerance: +/- 20%
- Power: 0.125W