Nozzle Throat 1.75mm 3D Printer PTFE

The module has two outputs: analog A0 and digital D0
Digital output D0 - signal 0 appears or 1 depending on the threshold setting
The threshold is set with the potentiometer
The sensor can be used for example:
Automatic watering for potted plants
With this module you will be able to measure the humidity of the soil, so that you will be able to control the humidity level of the soil of your plants
Characteristic:
Operation: 3.3V -5V
- Sensitivity adjustable by potentiometer
- Dual output mode: analog and digital
- Red LED - power indicator
- Green LED - indicator digital switching output
- PCB measurements: 3 x 1.5 cm
- Probe measurements: 6 x 3 cm

Printer Heating Controller MKS Mosfet for Heatbed Extruder MOS Module features:
- Superior performance of MOSFET
- Maximum current - up to 30A (heat sink)
- Can use control output signal Ramp1.4 (D8, GND-warm bed) and MKS series
- To control - 5-24V digital signal

LED Diode Assortment Kit 50x Red Green Yellow Blue White features:
  
- Lens color: Red, green, yellow, blue - diffuse, light white
- Size: 5 mm
- Operating current: 20mA
- Voltage (red) 1.8V-2.3V
- Voltage (green) 3.2V-3.4V
- Voltage (yellow) 1.8V-2.3V
- Voltage (blue) 3.0V-3.2V
- Voltage (white) 3.2V - 3.4V
- Anode (A): Positive (long leg): 17mm
- Cathode (K): Negative (shorter leg): 15 mm
- Operating temperature: -25ºC / 80ºC
- Welding temperature: + 260ºC
- Quantity: - 50 units
                  - 10x red
                  - 10x green
                  - 10x yellow
                  - 10x blue
                  - 10x white

Momentary Switch Push Button Black N/O 7mm features:
- Momentary pushbutton N/O (normally open)
- Black button
- Dimensions approx. 7 mm x 27 mm
- Recessed with nut and washer
- Load current (supported): 1A to 230V / 2A to 125V
- Drill to embed: 7 mm +/- 0.2
- Operating temperature: -55ºC to + 85ºC

The optical (reflective) module sensor with LM393 comparator, which detects obstacles with high accuracy. The ideal detector for obstacle detection for the installation of intelligent robots.TCRT5000: reflective optical sensor that has a compact construction where the light emitter and receiver are placed in the same direction to detect the presence of an object using infrared reflection on the object. The transmitter is an infrared LED and the receiver is a phototransistor. The sensor allows the detection of an object at a distance of up to 3.5 cm from the white paper and 1 cm from the person's finger.

Alligator clip connectors Red and  Black.

Sensor used to measure the temperature of the hotend or hot bed of your 3D printer
Characteristic:
- NTC Thermistor 100 K 3950
- Impedance: 100 K (25º of Temperature)
- Accuracy: 1%
- Sensor Diameter: 1.8 mm
- Cable Length: 1 m
- Cable: AWM UL 3398 150 ° C 300V
- Ready to be installed and used. Fully insulated
- Designed to withstand the high temperatures of extrusion of plastics such as PLA and ABS