NTC thermistor 100K 3950 1m RepRap cable

Resistor 10K Ohm 5% 0,25W 1/4W features:
-10K Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

PCB Circuit Board Marker Pen 1.0mm for printed circuits features:
-Permanent resistance ink to acid attack
-Ideal to write on almost any flat surface, such as PCBs, glass, plastic, metal, etc.
-Does not leave stains of ink, resistant to sunlight
-Quantity: 1.00mm - 1 unit

This module, which uses the exclusive L298P chip for driving high-power motors, can directly control two DC motors, with a drive current up to 2A. The motor output uses eight-speed Schottky diodes as protection.
The design of the letter allows you to connect directly to the Arduino UNO R3 for easier use. Module L298P DC 2A Motor Management Shield Bluetooth Interface PWM features:
- 1 logical step of the input voltage VD: 5 VDC
- Control of the input voltage VS and control by pulse width modulation:
      - VIN input: 6 - 12 VDC
      - PWRIN input: 4.8 - 35 VDC
- Logic current flow: Iss <36m A
- Operation current management: Io <2 A
- Maximum power dissipation 25W (T = 75 ° C)
- Input of the control signal:

L7805CV Voltage Regulator 5V 1.5A TO-220 features:
-Type Output: Fixed
-Voltage Output: 5V
-Manufacturer: ST Microelectronics
-Output current: 1.5A
-Max input voltage: 35V
-Input input min.: 5V
-Operational temperature: 0ºC to + 125ºC
-Encapsulated: TO-220
-Polarity: Positive

Red Laser Line Module Generator 650nm 5mW features:
- Type: red laser diode
- Type of laser: line
- Adjustable Focus
- Wavelength: 650nm
- Output power: 5mW
- Operating voltage: 4.5-5V
- Operating intensity: <40mA
- Operating temperature: -30ºC to 60ºC
- Dimensions of the emitter: Φ12x35mm
- Cable length: 130 mm

MKS MOS25 is the Mosfet printer heating module for heated bed that supports current up to 25A. We recommend MKS MOSFET, especially if you are trying to use a heated bed with your 3D printer and 12V power supply.

Characteristic: -Conductor: solid wire, tinned copper
-Insulation: PVC
-Low voltage electrical cables - Nominal voltage 300V / 80C -Standard: UL 1007
-Number of conductors: 22AWG, 1x0.35mm2
-Outer diameter: 1.6mm

This BLtouch sensor is an automatic leveling sensor for 3D printers that can accurately measure the inclination of your printing surface.
It can greatly improve the printing precision of your 3D printer.
Its features: are simple, smart and precise.
It could work with almost any type of bedding, such as glass, wood , metals, etc. 3DTouch's main functions and controls are the same as most automatic bed leveling sensors, consisting of an RC servo and a micro switch.

Self-leveling sensor BLtouch 3D printer features:
- Supply voltage: 5V.
- Supply current: 15mA
- Max. Current: 300mA
- Len3Dh cable: 150mm
- Wiring:
- 3 pins: Brown (-, GND) Red (+ 5V) Orange (control signal)