Filamento PETG Negro 1.75mm 1kg

Slide Linear Potentiometer 10K OHM kΩ features:
- Ideal for application in electronic circuits, MCU. ARM and Arduino projects
- Value: 10k Ohm
- Type: Linear variable resistance
- Tolerance: 20%
- Power: 250mW (1 / 4W)
- Dimensions 90x20 mm
- Analog voltage signal 0 - VCC
- Double outlet OTA, OTB
- Quantity: 1 unit

It allows controlling up to 2 direct current motors or a bipolar stepper motor. It also allows to control a unipolar stepper motor configured as bipolar.
Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32.
L298N Motor Drive Controller Board Module Dual H Bridge DC features:
- Minimum operating voltage: 5 V
- Maximum operating voltage: 35 V
- Maximum current: ± 2 A
- Logic voltage: 5V
- PWM signal inputs for speed control
- Outputs: for 2 DC motors or for a bipolar stepper motor
- Measures: 43x43x24 mm
Helpful Links:
Operation of the robot by Infrared / Operation of the robot by Bluetooth / Automatic operation with detection of obstacles

3A DC Converter 1,25-32V Adjustable LM2596 Step Down Module features:

- Based on the LM2596S-ADJ regulator
- Rectification: Asynchronous
- Output Voltage: 1.25v - 32v DC (adjustable)
- Voltage of Input: 3.2v - 35v DC
- Max Output Current: 3A (with heat sink)
- Ripple at output voltage: 30mV
- Frequency: 150KHz
- Max Conversion Efficiency: 92%
- Load Regulation: ± 0.5%
- Voltage Regulation: ± 2.5%
- Operating Temperature: -40ºC to + 85ºC
- Measurements 43x 21x 14 mm

Mechanical End of Career CNC Ramps1.4 3D Printer features:
- Mechanical limit switch, Endstop
- 100% brand new and high quality
- 1A 125V AC switch - Cable length: 70cm
- PCB dimensions: 40mm x 15mm

Blue 3D Pen and PLA Set of 20 colors Filament 1.75mm x 5m features:
- White
- Gray
- Yellow
- Orange
- Red
- Blue
- Green
- Black
- Pink
- Purple
- Luminescent green
- Gold
- Silver
- Transparent purple
- Transparent blue
- Transparent orange
- 4 random colors

2x Spring Tensioning Strap Printer features:
- Use with 6mm strap
- Timing Belt GT2 Tensioner Spring for RepRap Prusa Mendel 3D printer
- Fits 3D printer timing belt system
- Fits belt width: less than or equal to 6mm
- Constant force to keep belt reasonably tight to avoid losing steps, skipping steps or unwanted movements
- Material: Metal
- Silver color
- Size: 12 x 12 x 8 mm (length x width x height)
- Quantity: 2 units