Support 8mm Linear Axis XYZ CNC 3d Reprap Printer SK8 SH8

Version compatible with Arduino Nano V3.0
It has an ATMega328P chip running at 16Mhz with bootloader loaded factory.
Characteristic:
- Microcontroller: ATmega328
- Operating Voltage (logic level): 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins: 14 (6 PWM outputs)
- Analog Inputs: 8 (A0-A7)
- DC Current per I / O pin 40 mA
- Flash memory: 32 KB (2 KB used by the bootloader)
- SRAM: 2 KB
- EEPROM: 1 KB
- Frequency Clock: 16 MHz
- USB Communication - CH340
- Dimensions: 18 mm x 44 mm

MKS MOS25 is the Mosfet printer heating module for heated bed that supports current up to 25A. We recommend MKS MOSFET, especially if you are trying to use a heated bed with your 3D printer and 12V power supply.

8mm Bore Pillow Block Mounted Bearing is often suited to support rotating shaft applications.

3A DC Converter 1,25-32V Adjustable LM2596 Step Down Module features:

- Based on the LM2596S-ADJ regulator
- Rectification: Asynchronous
- Output Voltage: 1.25v - 32v DC (adjustable)
- Voltage of Input: 3.2v - 35v DC
- Max Output Current: 3A (with heat sink)
- Ripple at output voltage: 30mV
- Frequency: 150KHz
- Max Conversion Efficiency: 92%
- Load Regulation: ± 0.5%
- Voltage Regulation: ± 2.5%
- Operating Temperature: -40ºC to + 85ºC
- Measurements 43x 21x 14 mm

6-pin/10-pin Kanda DIL adapter features:
- Connector for Usbasp Programmer AVR Atmega8 Atmega128

Third hand stand for easy soldering of wires with a diameter from 1 to 5mm. Number of holes 5.

T8 Spindle 80cm with Trapezoid Nut R2 features:
- Type: Trapezoidal Screw
- Diameter: 8mm
- Tooth distance: 2mm
- Lengths: 800 mm
- Quantity:
* Nut 1 unit
* Spindle 1 unit

The integrated mainboard driver MKS-GEN L V1.0 for 3D printer has been developed by Makerbase to optimize existing problems on the open source controller board such as Ramps 1.4.
This product offers more flexible options for users.
MKS-GEN L V1.0 Integrated Controller Compatible with Ramps 1.4/Mega2560 R3 features:
- Mega2560 and Ramps 1.4 are integrated in the board, which avoids the complicated connectors.
- Supports a variety of step-by-step drivers such as A4988, DRV8825, TMC2100 and LV8729, available to change stepper motors and motors that users like.
- Reserve the signal from the external controller, available to connect an external high current driver to drive stepper motors 57 and 86.
se high quality MOSFET, better cooling and more stable.