Soldering Iron 40W

Characteristic: - Operating voltage: 3-6V
- Max flow: 80-120 l / h
- Maximum pumping height: 40-110cm
- Continuous working time of 500 hours
- Cable length: 20cm
- Inside outlet diameter: 5 mm
- Outside outlet diameter: 7.5 mm - Dimensions: 45mm x 23mm x 30mm

The module uses a 24-bit high precision A/D conversion chip HX711.
The input circuit can be configured to provide a bridge.
The electric bridge voltage sensor model (such as pressure, weight) is an ideal sampling module with high precision and low cost. HX711 Module Weighing Pressure Sensor 24 Bits features:
- Two selectable differential input channels
- Active low noise PGA with selectable gain of 32, 64 and 128
- Power supply regulator for load cell and ADC analog power supply
- Oscillator on chip that does not require external component with optional external glass
- Power-on-reset on the chip
- Simple serial control and serial interface: controls driven by pins, programming is not required
- Output data rate 10SPS or 80SPS selectable

Metal casing with Internal magnet Characteristic: - Power 2-3W
- Impedance: 4 Ohm - Shape: Round - Thickness: 5.3mm / 0.21 " - Diameter: 40mm / 1.6" - Quantity: 1 unit

40x Female-Female Cable 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Dupont female connectors on both ends
- Compatible with 2.54mm male connectors
- High quality and good working conditions
- Easy to install and use

Sonoff 433 MHz wireless remote control 4 buttons (IM160323001) This product can work with our smart home products: SONOFF RFR2, SONOFF SlampherR2, SONOFF 4CHPROR3, SONOFF RF Bridge 433, SONOFF TX.

COB LEDs are built as a matrix of LEDs, that is, a concentration of LEDs in a silicone coated tablet. The advantages of LED COB: - A light output of up to 120 lumens / watt (twice as much as LED SMD)
- The light intensity is greater without concentrating the beam of light
- Greater durability
- Angle of opening up to 160ºC
- Multidirectional light Mount LED diode on a good heatsink, add some fan, this is necessary because you have to "remove" the heat from the surface of the board so that the LEDs last longer.
Place a little thermal silicone in each of the diode placement centers.

Relay Module DC 12V 10A 1 Channel Low/High Trigger features:
- Channel: 1 (protected with Optocoupler)
- Supply voltage: 12V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- Trigger signal type jumper (low / high)
- LED indicator
- Dimensions: 30x 54mm
- Has a jumper that allows to choose type of trigger signal (low / high)