Medical sensors

This sensor from Advancer Technologies is an improved version of the bestseller from this producer. It got several upgrades including single supply voltage of 3.1V up to 5V, polarity protection in the power pins output and RAW EMG. 

This a pack of 10 disposable electrodes is for biomedical measuring including EEG. Best suited for monitoring of neuro- and bio-feedback purposes. These are a single use, however very user friendly thanks to the latex-free gel.

This is not a medical device and is to be used for strictly educational purposes.

This tiny little board features two chips from Maxim Integrated: MAX32664 and MAX30101. The 30101 Oximetry module  is the sensor on board responding for both oximetry and heart rate sesnsing. The MAX32664 is equipped with a Cortex M4 handling algorithimc calculations, digital filtering and automatic gain control. The board comes with I2C and SparkFun has provided to it Qwiic connectors for ease of use.

This Shield provides a 3.5mm connector where you can connect a three-electrode sensor cable, allowing you to test and use the MyoWare muscle sensor without actually connecting it to your person.

Simple breadboard for your MyoWare Muscle Sensor. You can use the provided area of the shield to solder in any custom circuit you can think of. This shield provides 8 x 15 solderable through holes on a standard 0.1" grid.

This is the MyoWare Muscle Sensor Development Kit, an Arduino-powered electromyography (EMG) sensor kit that gives you the MyoWare, each MyoWare Shield and everything you need to connect them all together.

MyoWare Power Shield is designed to use two standard CR2032 coin cell batteries to power the MyoWare muscle sensor. These will be connected in parallel for extended capacity at a nominal 3.0V.

This is your simple three conductor sensor cable with electrode pad wires. These cables measure 24" long and feature a 3.5mm audio jack on one end with snap type receptacles for biomedical sensor pads.

Sparkfun sensor  MyoWare® 2.0 from Advancer Technologies is a newer version of this producer's bestseller. The MyoWare 2.0 muscle sensor included in this kit has been redesigned from the ground up with a new compact and easy-to-use design, and has been updated with the latest, most advanced chipset to improve sensor performance and reliability. In addition, MyoWare has developed a range of shields that work with the sensor (in our LED shield offering, displaying sensor readings as LED lights).

This Cable Shield provides a 3.5mm connector where you can connect a three-electrode sensor cable, allowing you to test and use the MyoWare 2.0 muscle sensor without actually connecting it to your person.

Sparkfun MyoWare 2.0 Muscle Sensor Development Kit  is an all-in-one electromyography (EMG) sensor kit compatible with Arduino. Just snap on a MyoWare 2.0 Shield, add some EMG sensor pads, connect the sensor to a muscle group and flex! The kit also includes the SparkFun RedBoard Plus is an Arduino compatible board and the MyoWare 2.0 Arduino Shield to connect the MyoWare® 2.0 sensor via a cable to the Arduino.