Flange Bearing F605ZZ Ball Bearing 3D Printer Reprap Prusa

Sensor Module GUVA-S12SD UV features:
- The module based on the Schottky-type photodiode - applicable to the optical mode
- This is a " true "UV sensor instead of calibrated light sensor
- It has high sensitivity, high stability, good linearity
- Power supply: 2.5V - 5V
- Analog output
- Captured wavelength: 240-370nm
- Ultra low power consumption
- Meteorological applications, skin care, industrial UV level measurement
- PCB dimensions: 11x27mm

2x CNY70 Reflective Optical Sensor with Transistor Output features:
- Reflective optical sensor with transistor output
- Reflective optical coupler used to distinguish edge or line detection
- Dimensions of the housing are 7 x 7 x 6 mm
- Supply voltage: 5V
- Maximum diode current: 50 mA
- Maximum collector-emitter voltage: 32V
- Maximum collector current of 50 mA
- Quantity: 2 units

Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 2 poles 5.08mm pitch features:
Number of Contacts: 2
Pitch: 5.08mm
Number of Rows: 1
Mounting Type: PCB
Gender: Male
Allowable Section: 1.5mm2 (22- 14 AWG)
Termination method: screw
Type: screw terminal block
Nominal current: 16A
Nominal voltage: 250V
Color: blue
Material: Nylon 66
Depth: 10mm
Width: 7.5mm
Length: 10mm

Flat Cable GPIO 40 Pins M/F features:
- For Raspberry Pi 2 and Pi 3, B and B +
- Total length 20cm
- Quantity: 1 unit

Characteristic: - Supports up to 280ºC
- Electrical and antistatic insulation
- Resistant to acid and alkaline products
- Resistant to solvent
- Adhesive
- Length Approx: 33m
- Polyamide adhesive tape 10mm 
- Known as Kapton polyamide tape
- Product for welding works on those that need to protect some component from the heat

Voltmeter Amperemeter DC Red and Blue 100V 10A features:
- Supply voltage: 4.5V to 30V
- Voltage measurement range: 0V to 100V (± 1%)
- Min voltage resolution: 0.1V
- Current measurement range: 0A to 10A (± 1%)
- Min current resolution: 0.01A
- Operating current: 5mA to 15mA
- Display: Red LED color (Voltage) and Blue LED color (Intensity)
- Includes reverse polarity protection
- Measurement refresh time: 500ms
- Screen dimensions: 48 x 29 mm
- Recessed hole: 45.5 x 26.5 mm
- Depth: 21 mm
- Cable length: 150 mm
- Operating temperature: - 10ºC to 65ºC
- No battery needed
- Dual panel with voltmeter and digital ammeter

Pulley GT2 20 Teeth 8mm Bore Aluminum 3D Printer Reprap features:
- Number of teeth: 20
- Pitch: 2mm
- Material: Aluminum alloy
- Outside diameter: 16mm
- Inner hole: 8mm
- Use with strap: 6mm and 6.35mm
- Toothed width 7mm
- Quantity: 1 unit
- Ideal for fixing on the axis of the motors of your 3D printer