Flange Bearing F605ZZ Ball Bearing 3D Printer Reprap Prusa

Flexible Coupler 5mm/8mm Z-axis CNC 3D Printer features:
- High quality flexible aluminum coupler with which you can connect Nema 17, 5mm stepper motors to an 8 mm threaded rod
- They incorporate 4 captive screws so that you can perfectly fix the couplings to the rod
- Material: Aluminum alloy
- Coupler height (L): 25 mm
- Outside diameter: 18mm
- Shaft diameter: 5mm / 8mm

Servos Tester features:
- 3-Channel Tester
- For Electronica Arduino

Multimeter Cable Polymeter Jack Alligator Clip Banana Plug features:
- Length: 90cm
- Colors: red and black
- 4mm diameter plug
- Quantity: 2 Cables

Pulley GT2 60 Teeth 5mm Aluminium 3D Printer Reprap CNC features:
- Number of teeth: 60
- Pitch: 2mm
- Material: aluminum alloy
- Outside diameter: 44mm
- Inner hole: 5mm
- Use with strap: 6-7mm GT2 Ideal to fix on the axis of the motors of your 3D printer, CNC machine.

Machine Cup Grease with Dispenser 65ml features:
- Product designed for lubrication of various bearings, joints and guideways. It works in temperatures from -24°C to 135°C at high loads. Resistant to washing-out with cold water. Provides protection against corrosion

Premium Bobina para Impresora 3D

High power digital servo, better precision than the MG995. MG996R Metal Gears Digital Servo High Power Equivalent 12Kg 6V features:
- Operating voltage: 4.8 V to 7.2 V
- Consumption: 100mA
- Torque max.: 12kg / cm (6V)
- Operating speed: 0.22sec / 60degree (4.8V), 0.19sec/60degree (6V)
- Max. Radio: 180ºC
- Temperature range: 0-55 degrees
- Weight: 55 g
- Cable length: 29cm
- Dimensions: 54 x38x 20 mm
- Servo connector: JR (JR and Futaba adaptable)

The module uses a 24-bit high precision A/D conversion chip HX711.
The input circuit can be configured to provide a bridge.
The electric bridge voltage sensor model (such as pressure, weight) is an ideal sampling module with high precision and low cost. HX711 Module Weighing Pressure Sensor 24 Bits features:
- Two selectable differential input channels
- Active low noise PGA with selectable gain of 32, 64 and 128
- Power supply regulator for load cell and ADC analog power supply
- Oscillator on chip that does not require external component with optional external glass
- Power-on-reset on the chip
- Simple serial control and serial interface: controls driven by pins, programming is not required
- Output data rate 10SPS or 80SPS selectable